Cool Mango Al Fakher Hypermax Prime 50K Prefilled Pod Kit

Cool Mango Al Fakher Hypermax Prime 50K Prefilled Pod Kit

The Cool Mango Al Fakher Hypermax Prime 50K Prefilled Pod Kit pairs a 1000mAh battery with a Snap Dual module and two prefilled 10ml containers. Its puff ceiling is quoted at up to 50,000, and both containers hold Cool Mango nicotine salt at 20mg/ml.

Alphonso mango leads the flavour, with a menthol chill on the exhale, and the draw can be set between restricted and open direct-to-lung. Refills for the Cool Mango 50k are bought as Hypermax Prime 50K refill pods, and the kit is sold individually or in fives and tens.

What to Know About the Cool Mango Hypermax Prime Kit

• Up to 50,000 puffs, depending on usage
• 2 x 10ml Cool Mango nic salt containers at 20mg/ml
• 1000mAh battery with USB-C charging
• Quick Charge 2.0 support
• Adjustable airflow for RDL and DTL vaping
• Compatible with Hypermax Prime 50K refill pods

Features of Cool Mango Al Fakher Hypermax Prime 50K Prefilled Pod Kit

Five parts of the design are covered below: the puff rating, module, containers, battery with display, and activation with airflow. Hardware of this type is gathered under Prefilled Pod Kits at the store.

Up to 50,000 Puffs

Short, light draws are what the up to 50,000 puff ceiling assumes. Longer pulls empty the containers sooner, so totals are lowered by draw length and output mode, and results differ from person to person. More high-puff devices can be browsed under Big Puff Vapes.

Snap Dual Mesh Coil Module

A 2ml Snap Dual module sits at the centre of the kit and holds the integrated 0.6ohm mesh coil. The two containers click into the sides of the module, and the module is then docked into the battery. Heat is spread widely by a mesh coil, which supports the dense, open draw of this kit.

Two Prefilled 10ml Containers

Each kit is supplied with a pair of 10ml containers pre-loaded with Cool Mango, and the nicotine salt inside measures 20mg/ml (2.0%). Two 10ml containers are supplied, not one larger bottle.

1000mAh USB-C Battery and LED Display

Power comes from a 1000mAh rechargeable battery, charged over USB-C with Quick Charge 2.0 supported. An integrated Silk Glow LED screen shows the battery percentage and pod activation status. Type-C leads are stocked separately under Chargers And Cables.

Draw Activation and Airflow Slide

Nothing needs pressing, since the kit is woken by inhale: it is draw-activated. Airflow is adjusted with a mechanical slide switch on the side of the battery unit. The draw is open, running from restricted direct-to-lung (RDL) to direct-to-lung (DTL).

How to Set Up the Cool Mango Hypermax Prime Kit

Assembly takes a few clicks and no priming. The steps follow in order.

Step 1: The protective silicone bungs and seals are removed from the battery base, the module, and both 10ml containers.

Step 2: Both containers are pushed into the module tracks until they click flush.

Step 3: The assembled module is docked into the battery housing.

Step 4: A rest of 2 to 3 minutes is then given upright, and the mesh coil absorbs the liquid in that time.

Step 5: A first draw is then taken, with the airflow slide moved towards the style preferred.

What's in the Cool Mango Hypermax Prime Kit Box

The bigger packs repeat the same contents, which are listed here.

• 1000mAh battery base unit
• Snap Dual pod module
• Two prefilled 10ml containers of Cool Mango
• User manual

Charging leads are absent from this list, and the two larger sizes contain five or ten full kits.

Devices Compatible With the Cool Mango Hypermax Prime Kit

Refills are limited to Al Fakher Hypermax Prime 50K Refill Pods, so the kit is exclusively compatible with that range. It is not backwards-compatible with Hypermax 30K or Crown Bar systems. Spare sets are collected under Vape Pods.

The Hypermax Prime 50K name should be on any refill pack before it is ordered for the Cool Mango Al Fakher vape.

About Al Fakher and the Hypermax Prime Range

The idea behind this Hypermax Prime 50 K vape is few controls: draw activation and a single airflow slide. Al Fakher builds its hardware around an open, dense draw in the style of a shisha lounge, so the kit sits at the direct-to-lung end rather than the tight pull of a cigarette.

The coil is carried by the module, while the battery housing stays a simple dock. Other Al Fakher 50k devices sit under Big Puff Pod Kits.

Stock Up on the Cool Mango Hypermax Prime Kit

Once the first pair of containers is empty, a second Cool Mango 50k set is the natural next purchase, and those sit under Replacement Pods. Free Pirate Post applies once a basket's subtotal passes £40, discounts deducted.

Same-day dispatch on Tracked 24 applies when checkout and the age check finish ahead of the 3:30 pm weekday cut-off. An age check forms part of the Pirate Vapes checkout, as buyers must be over 18.

Conclusion

Adults looking for an open-draw Al Fakher Hypermax vape in one mango flavour are catered for by the Cool Mango Hypermax Prime 50K kit, and refill pods for it are easily reordered. Pods from other ranges are not accepted.

Further ready-to-use devices are on the Rechargeable Vapes page, while Pirate Vapes carries pods, liquids and pouches too.

FAQs

How many puffs does the Cool Mango Hypermax Prime 50K kit give?

Short, light draws can stretch one system to up to 50,000 puffs, while longer draws use the containers faster and most people see a lower count.

What comes in the Cool Mango Hypermax Prime kit box?

Each kit holds a battery base, a Snap Dual module with its mesh coil, two prefilled 10ml Cool Mango containers, and a user manual. A Type-C cable is bought separately.

Which refill pods fit the Cool Mango Al Fakher vape?

Hypermax Prime 50K refill pods are the match, while pods from the Hypermax 30K and Crown Bar ranges do not fit. A pod swap is made on the same battery.

How is the Cool Mango Prime 50K kit charged?

A USB-C port handles charging, with Quick Charge 2.0 supported. Battery percentage and pod activation status appear on the Silk Glow LED screen.

How does the Cool Mango Hypermax Prime kit draw?

Draw style spans RDL through DTL, and airflow is set with a slide switch on the battery unit. Drawing on the mouthpiece activates the kit, so no button is involved.

How long should the Cool Mango Hypermax Prime kit stand before the first puff?

A wait of 2 to 3 minutes upright is advised after the containers are clicked into the module. That gives the mesh coil time to saturate with e-liquid.