Innokin Sceptre Replacement Pod

Innokin Sceptre Replacement Pod

A tired pod is the usual reason a good little kit starts to disappoint. The Innokin Sceptre Replacement Pod puts that right: a 2ml refillable cartridge for the original Sceptre kit that takes the full Innokin Sceptre coil range, so one pod covers both a tight MTL draw and a looser RDL one. Side fill, leak-resistant, with airflow you adjust on the pod itself.

Coils drop in from the base, which means you replace a cheap coil rather than the whole cartridge. Pirate Vapes keeps these among its Replacement Pods for exactly that reason.

Why vapers choose this:

• Replaceable coils, not disposable pods, means the coil drops out of the base and a fresh one drops in, so you are not binning a whole cartridge every time flavour fades, which keeps running costs down and plastic waste with it.

• One pod, two vaping styles through the 0.5ohm RDL and 1.2ohm MTL coils.

• Side fill with a silicone stopper keeps refills quick and leaks rare.

• Adjustable side airflow dials the draw from tight to open without pulling the pod out.

• 2ml TPD capacity stays clear enough to watch your level at a glance.

Innokin Sceptre Replacement Pod Features

Swap the Coil, Keep the Pod

The pod opens at the base, so a spent coil lifts out and a fresh one presses in. The change takes seconds. Since a coil costs a fraction of a full pod, you are only replacing the part that actually wears. Browse the Vape Coils section for Sceptre spares.

MTL or RDL, Your Call

Fit the 1.2ohm coil for a tight, cigarette-style mouth-to-lung draw that suits higher-strength salts. Drop in the 0.5ohm mesh for a warmer, restricted direct-lung pull with more vapour. The side airflow ring fine-tunes either one. Two very different vapes from a single pod.

What Should You Fill It With?

For the 1.2ohm MTL coil, 50/50 blends and Nic Salts at 10mg or 20mg work best. For the 0.5ohm RDL coil, thicker juice up to around 70% VG shines. If you like 70/30 Shortfills, that is the coil to run them through.

Built to Stay Sealed

The side fill port seals with a silicone bung, and the pod is designed to keep liquid where it belongs. Honestly, a leaky pod is the fastest way to fall out of love with a kit, so a cartridge that stays sealed through daily refills is worth more than the spec sheet suggests.

Watch Your Level

The 2ml pod is clear enough to eyeball your e-liquid without lifting it out of the device. Small thing, but topping up before you run dry saves the coil from a burnt, dry hit. Refill at around a quarter left, and the coil lasts noticeably longer.

Innokin Sceptre Coil Options

The pod is built for the Innokin Sceptre coil family. Two do the heavy lifting, with a couple of extra resistances floating around the wider S-Coil range.

Start here: the 0.5ohm RDL mesh. Rated around 18W to 20W, it opens the draw up for restricted direct-lung vaping with fuller vapour and bold flavour. Pair it with higher-VG juice to get the best from it.

The MTL option: the 1.2ohm. Running nearer 9W to 10W, it tightens everything down for a mouth-to-lung draw that carries higher-strength salts smoothly. This is the one most ex-smokers reach for.

Worth knowing: a 0.65ohm MTL sits between them at roughly 10W to 12.5W. (Note: The 0.25ohm S-Coil is for the Innokin Sensis only and will not work in the Sceptre).

#buttons

• 0.5ohm RDL Mesh
• 0.65ohm MTL
• 1.2ohm MTL

How to Set Up the Innokin Sceptre Pod

Under two minutes, start to finish.

1. Twist the base to open the pod. Unscrew the spent coil from the base adapter, screw the fresh coil into the adapter until finger-tight, then twist the base back onto the pod.

2. Prime the coil. Drip a few drops of e-liquid directly onto the exposed mesh so it is wet before it ever fires.

3. Fill the pod. Lift the silicone stopper on the side and fill with your 50% PG or higher (MTL) or higher-VG (RDL) e-liquid, then press the stopper back down.

4. Seat the pod into the Sceptre until it clicks home.

5. Let it stand for a solid six minutes so the wick soaks through fully. This wait is the single biggest thing standing between you and a burnt first coil.

6. Set your airflow on the side ring, tight for MTL or open for RDL, then take a few gentle draws to start. 

What's in the Innokin Sceptre Pod Box

• 1 x Innokin Sceptre Battery Mod (1400mAh capacity)

• 1 x Innokin Sceptre Pod (3ml capacity)

• 1 x 1.2ohm Sceptre MTL Coil (Pre-installed)

• 1 x 0.5ohm Sceptre RDL Mesh Coil (Spare)

• 1 x Micro-USB Charging Cable

• 1 x User Manual / Quick Start Guide

• 1 x Warranty / Warning Booklet

Made for the Innokin Sceptre Pod Kit

This is the original Sceptre pod, made for the Innokin Sceptre Pod Kit. If that is the device in your hand, this is the cartridge it takes, and it runs the full Sceptre coil range for MTL or RDL vaping.

One thing to get right: the Sceptre 2 uses its own pod, not this one. If you upgraded to the second-generation kit, you need the Sceptre 2 pod instead. The Sceptre coils themselves cross over to a few other Innokin devices, such as the EQ Filter for the 1.2ohm, but the pod is Sceptre-specific. For more from the brand, browse the Innokin Range.

About Innokin

Innokin has been making mouth-to-lung hardware since the early days of UK vaping, and the Sceptre sits squarely in that tradition. The brand built its name on approachable, dependable kits like the Endura and the Sceptre, devices designed for vapers who want something simple that just works rather than a menu of settings.

The Sceptre pod reflects that: replaceable coils to keep running costs down, side airflow to suit different draws, and a refillable build that skips the waste of sealed cartridges. For a reliable MTL-first pod system, Innokin is still one of the trusted names.

Stock Up and Save

Pods do not last forever. Even with replaceable coils, the cartridge itself softens and clouds over time, so keeping a spare on the shelf saves a dry evening. If you run the Sceptre daily, setting a pod and coils to arrive on

The Crow's Nest means you are never caught short. Pirate Vapes dispatches every order the same day before 4 pm, with an age-verified checkout and over-18s only. Free Pirate Post lands once you spend over £40.

Conclusion

The Sceptre replacement pod is the cheap, sensible fix when a good kit starts to feel tired. Replaceable coils mean you swap a coil rather than a whole cartridge, and the same pod handles both a tight MTL draw and a looser RDL one depending on what you fit.

Fill it with salts for a firm mouth-to-lung hit or higher-VG juice for more vapour, adjust the airflow to taste, and the Sceptre feels new again. Browse the full range of Vape Accessories and pick up your pods at Pirate Vapes.

FAQs

Which kit does the Sceptre pod fit?

The original Innokin Sceptre Pod Kit. If you have the Sceptre 2, you need the Sceptre 2 pod instead, as the two are not the same cartridge.

Does it come with the Sceptre coils?

That depends on the pack. Some Sceptre pods include a coil or two; others are sold as the empty pod. Check the option before you order and grab Sceptre coils separately if needed.

MTL or RDL, which Sceptre coil do I want?

The 1.2ohm for a tight mouth-to-lung draw with salts. The 0.5ohm mesh for a looser restricted direct-lung draw with more vapour. The side airflow tunes both.

How do I fill the Sceptre pod?

Lift the silicone stopper on the side, fill with your e-liquid, and press it back down. Match the liquid to the coil: 50/50 or salts for MTL, higher VG for RDL.

How long does a Sceptre pod last?

Weeks, usually, since the coil is the part that wears and you replace that separately. Swap the pod itself when the plastic clouds, the seals soften, or the flavour will not clean up.

What capacity is the Sceptre pod?

2ml in the UK, in line with TPD limits. Enough for a good stretch of vaping before a refill.