Kiwi Passion Fruit Guava Elf Bar Elfa Pro Prefilled Pods

Kiwi Passion Fruit Guava Elf Bar Elfa Pro Prefilled Pods

Kiwi Passion Fruit Guava Elf Bar Elfa Pro Prefilled Pods are sealed 2ml pods with a 1.2ohm QUAQ mesh coil inside, supplied in packs of 2, 10, or 20. The liquid is an even PG/VG split with 20mg/ml nicotine salt, and puffs run up to 600 for each pod, dropping on long draws.

Only one flavour is offered: a tropical mix of kiwi, passion fruit, and guava, with a tight MTL (mouth-to-lung) pull. Pods cannot be topped up. Once a pod runs out, a new one takes its place in an ELFA Pro or original ELFA kit, and all three pack sizes hold the same flavour.

What to Know About the Elf Bar Elfa Pro Pods

• 2ml sealed pod holding 20mg/ml nicotine salt, with PG and VG at 50/50
• Rated for up to 600 puffs from each pod, and long draws reduce that
• Built-in 1.2ohm QUAQ mesh coil, so the pod is not refillable
• Fits the ELFA Pro, ELFA, ELFA Turbo, Lost Mary Tappo, and Elf Bar 600 kits
• PRESS base to push in, then wait 3 to 5 minutes before the first draw

Features of Kiwi Passion Fruit Guava Elf Bar Elfa Pro Prefilled Pods

Capacity, strength, coil, activation, pod design, and flavour decide how these pods behave in the kit. Similar sealed pods are listed under Vape Pods.

Sealed 2ml Pod, Up to 600 Puffs

Every pod is sealed at 2ml, which is as much as UK law allows a nicotine pod to hold. A nicotine salt at 20mg/ml, the legal ceiling, is blended with PG and VG in equal parts. Other products at this level are gathered in 20mg Nic Salts. A rating of up to 600 puffs belongs to one pod, while 1,200 describes the two-pod box, which is how Elfa Pro 600 puff pods are quoted.

QUAQ Mesh Coil at 1.2ohm

An integrated 1.2ohm QUAQ mesh coil is fitted in each pod, made from ultra-fine woven mesh and non-woven cotton to heat quickly and keep the flavour steady. Pulls are mouth-to-lung (MTL), tight and cigarette-style, and the kit starts on the inhale. Kits with the same style are gathered under MTL Vape Kits.

ECS Press Base

Elf Bar's ECS (E-Liquid Coil Separation) design keeps the e-liquid in a sealed upper reservoir, away from the wick and coil, while the pod is shipped and stored. The base marked PRESS is pushed upward to break a silicone barrier, and the liquid then runs down into the coil chamber.

Clear-View Pod

Transparent, tinted PCTG forms the casing, which makes the liquid level easy to read. Opaque casing hides it on the original ELFA pods. Two magnets hold the pod in the kit and snap it into place.

Kiwi, Passion Fruit and Guava Flavour

Tart green kiwi opens the flavour, and sharp, aromatic passion fruit follows it. Pink guava sits underneath, adding a creamy, fragrant sweetness that rounds off the blend. This is the only flavour on the page, and every pack size holds it.

How to Swap Elfa Pro Pods

A swap takes about five minutes, most of it spent waiting. The wick in these pods is dry when they arrive, so the base is pressed before the pod goes into the kit.

Step 1: The new pod is taken out of its blister foil, and the base marked PRESS is pushed upward with a thumb until it clicks flush with the casing.

Step 2: A silicone hygiene plug sits in the mouthpiece and is pulled out, then the adhesive sticker over the contacts and airflow hole is peeled away.

Step 3: The pod is left upright for 3 to 5 minutes so that the wick around the coil can saturate. A draw taken too early burns the dry coil.

Step 4: Any used pod is lifted out of the kit, and the new one is dropped into the cavity until the magnets snap it into place.

Step 5: The kit is started by inhaling, and the first few draws should be gentle.

Step 6: The kit is charged through its Type-C port when the battery runs low, and the next pod is fitted when the flavour fades. A used pod is never refilled.

What's in the Elfa Pro Pods Pack

Sealed pods are the only items supplied, and every retail box holds 2 pods of 2ml each.

• 2 prefilled pods in the pack of 1, holding 4ml of e-liquid in total
• 10 prefilled pods in the pack of 5, made up of five boxes of two
• 20 prefilled pods in the pack of 10, made up of ten boxes of two

An ELFA Pro kit, a charging cable, and spare e-liquid are not included.

Devices Compatible With the Elfa Pro Pods

Five devices accept these pods. Native fit comes with the Elf Bar ELFA Pro Pod Kit, which has a 500mAh battery charged through a USB-C port, and the original Elf Bar ELFA Pod Kit takes them too. Next, the ELFA Turbo kit detects the 1.2ohm coil and sets its output to standard wattage, while the Lost Mary Tappo shares the same magnet alignment, pod cavity, and airflow layout. The reusable Elf Bar 600 pod kit also takes them.

Hardware is stocked in Prefilled Pod Kits and Lost Mary Vapes, and ELFA Pro pods UK buyers can match a kit by the model name printed on it. Pods made for other Elf Bar systems have their own listings, so the kit name should be compared with the five above before an order is placed.

About Elf Bar and the ELFA Pro Pod System

The ELFA Pro kit pairs a 500mAh rechargeable battery and a Type-C port with the clear-view ECS pod. The original ELFA kit uses a battery of the same size with opaque pods, and it still accepts the newer pods.

Only the pod is replaced when a flavour runs out, so changing flavour needs another pod and never another device. More of the brand's hardware and pods are collected in Elf Bar Vapes.

Stock Up and Delivery

A Pack Of 10 can be kept to hand by anyone running the Pro kit on one flavour, and Elf Bar kiwi guava pods can share a basket with a second ELFA Pro flavour. Pod deals sit in Multi-Buy Vapes.

Pirate Vapes dispatches same day for orders that beat the 3:30 pm weekday cut-off, and checkout is open to over-18s only.

Conclusion

Owners of an ELFA Pro, ELFA, ELFA Turbo, Lost Mary Tappo or Elf Bar 600 kit who want one tropical flavour in a sealed 2ml pod at 20mg/ml are the people these pods suit. A single spare or a longer run between orders is covered by the packs of 2, 10 and 20.

A spare lead is easy to find in Vape Accessories, and the rest of the pod range is kept at Pirate Vapes.

FAQs

How many puffs does a Kiwi Passion Fruit Guava Elfa Pro pod last?

A single pod is rated for up to 600 puffs. That figure is lowered by long draws and heavy use, and a figure of 1,200 puffs refers to the complete two-pod box rather than to one pod.

What strength are the Kiwi Passion Fruit Guava Elf Bar Elfa Pro Prefilled Pods?

Each pod holds 20mg/ml of nicotine salt, which is the UK maximum, with PG and VG split evenly. Only that strength is listed in this flavour, so Elfa Pro nic salt pods like these are for existing nicotine users and are not nicotine-free.

Which kits take the Elfa Pro kiwi pods?

The ELFA Pro, original ELFA, ELFA Turbo, Lost Mary Tappo, and Elf Bar 600 kits all take them. Pods for other Elf Bar devices have their own listings, and the model name on the kit is the quickest way to check a match.

Can the Kiwi Passion Fruit Guava Elfa Pro pods be refilled?

Refilling is not possible because the e-liquid and the mesh coil are sealed together in one pod. A finished pod is thrown away, and the next one from the pack takes its place.

How many pods come in each pack of Kiwi Passion Fruit Guava Elfa Pro pods?

The Pack Of 1 holds 2 pods, the Pack Of 5 holds 10, and the Pack Of 10 holds 20. Every pod has the same kiwi, passion fruit, and guava flavour, so a bigger pack adds quantity and never a second flavour.

How long should the Kiwi Passion Fruit Guava Elfa Pro pods be left before the first draw?

The base is pressed in first, and the pod is then left upright for 3 to 5 minutes so that the dry wick can saturate. Vaping straight away would burn the coil, which is why the wait is part of every swap.