Crystal Pro CP 10K Prefilled Pods

Replacement pods for the Crystal Pro CP 10K kit. Each pack holds 12ml of e-liquid in total: a pod at 2ml with a 0.8ohm mesh coil already fitted, and a container at 10ml that feeds the pod as you draw. Nicotine strength is 20mg across every flavour.

The coil arrives pre-primed, so there is nothing to soak, fill, or swap out. When a set runs dry, pull the spent unit from the device and snap the next one in. Twenty flavours cover fruit, ice, candy, and menthol profiles. Over 18s only.

Why Vapers Choose Crystal Pro CP 10K Prefilled Pods:

• 12ml of capacity per pack. A pod and container working together give you roughly 10,000 puffs before a swap. Most vapers get one to two weeks from a single pack depending on draw habits.
• No coil changes, no priming wait, no loose bottles. The mesh coil arrives ready inside every pod. Remove the old unit, click the new one in, draw.
• Gravity-fed system keeps the coil wet. The container feeds liquid into the pod through a sealed path. No manual top-ups, no tilting, no monitoring required. Flavour stays consistent right through to the end.
• 20 flavours to rotate through. Fruit, ice, candy, and menthol options give you enough variety to switch between packs without touching the device itself.
• Running costs sit below disposables. At 12ml per pack, the per-puff cost of the CP 10K system beats single-use alternatives significantly, especially through Value Bundles.

Crystal Pro CP 10K Prefilled Pods Features

Up to 10,000 Puffs Per Pack

Each refill pack combines a 2ml pod with a 10ml auto-refill container for 12ml of nic salt total, rated at approximately 10,000 puffs. That is roughly equivalent to 17 standard 600-puff disposables from a single purchase. Actual count depends on draw length and frequency.

Factory-Fitted 0.8ohm Mesh Coil

Every pod ships with a 0.8ohm mesh coil sealed inside and already primed. Mesh distributes heat across a broader surface than wire coils, pulling more flavour from the e-liquid on each draw and producing steadier vapour density. Because the coil is enclosed within the pod housing, you never touch it. When the pod empties, the coil goes with it, and the replacement arrives with a fresh one fitted.

45-Flavour Range Across Two Strengths

The CP 10K refill range covers 45 flavours at 20mg and 15 at 0mg, spanning fruit blends, iced profiles, menthol, candy, and soda options. Every pod uses the same 0.8ohm mesh coil regardless of strength, so the draw feel and vapour output stay consistent whether you run nicotine or nicotine-free. You can mix flavours and strengths freely between packs without affecting the device.

Leak-Resistant Sealed Design

The pod-and-container connection uses a sealed click-fit mechanism that prevents e-liquid from leaking out during normal use or transport. The 2ml pod chamber is fully enclosed, so there are no fill ports, no exposed wicks, and no openings where liquid could escape. This keeps the device, your pockets, and your hands clean between swaps.

Single-Piece Snap Connection

The assembled pod-and-container unit snaps into the CP 10K device in one motion. No threading, no alignment, no adapters. The connection is exclusive to this device: a CP 10K pod will not physically connect to any other Suonon model or third-party hardware. The dedicated fit keeps every pod firmly seated with no air gaps.

Crystal Pro CP 10K Prefilled Pods Flavours List

The CP 10K refill range covers 45 flavours at 20mg and 15 flavours at 0mg. Every pod uses the same 0.8ohm mesh coil regardless of strength. The lineup spans fruit blends, icy profiles, candy, soda, and menthol options. The 0mg pods suit vapers stepping down from nicotine or those who want the flavour and draw without it.

How to Set Up the Crystal Pro CP 10K Prefilled Pods

1. Remove the pod and container from the packaging. Peel off any stickers or protective wrapping from both pieces.
2. Remove the silicone seal from the base of the pod.
3. Unscrew the cap from the top of the container.
4. Press the pod firmly onto the container until you hear the click-fit engage.
5. Pull the old pod-and-container assembly straight out.
6. Slide the assembled pod-and-container into the device until it seats firmly.
7. Wait 2 to 3 minutes for the mesh coil to fully saturate before drawing.
8. Draw to vape. The device fires on inhale. No buttons required.

What's in the Crystal Pro CP 10K Prefilled Pods Box

Each pack contains two pieces: 

• One pod (2ml, 0.8ohm mesh coil fitted inside)
• One container (10ml) that clicks onto the pod. 

The pack does not include the device. You need the Crystal Pro CP 10K kit (sold separately) to use these pods.

Built for the Crystal Pro CP 10K

These pods fit the Crystal Pro CP 10K device only. Pick up the Crystal Pro CP 10K kit at Pirate Vapes if you need the device.

About Crystal Pro

Suonon is the manufacturer behind the Crystal Pro range. The brand made its name with the Crystal Pro Max 10000, a transparent-shelled disposable that became one of the most recognised high-puff devices in UK vape shops before the single-use ban took effect in June 2025.

When the original Max 10000 was pulled from sale (its 18ml e-liquid capacity exceeded TPD limits), Suonon pivoted to the CP 10K: a rechargeable Prefilled Pod Kit that reaches the same 10,000-puff lifespan through a compliant pod-and-container system. 

The Crystal Pro range now sits at the centre of Suonon's product lineup, which also includes the compact CP 600 for lower-puff use. All Suonon products are TPD-compliant and MHRA-registered for UK sale.

Stock Up and Save

If the CP 10K is your daily device, you will go through a pod pack every one to two weeks. Keeping a spare set around means no gaps between flavours. Orders over £25 qualify for Free Delivery at Pirate Vapes, and anything placed before 4 pm ships the same day. Picking up multiple packs through our Value Bundles brings the per-pack cost down.

Auto Refill handles reordering on a schedule you set, with savings on every shipment. Pirate Vapes only stocks MHRA-registered pods. We carry all 20 flavours in the CP 10K refill range.

Conclusion

These pods handle the one job that matters: they keep your CP 10K device running with a fresh coil and a full container every time you swap. The gravity-fed system holds flavour steady right through each 10,000-puff run, and the sealed pod removes any need for coil changes, manual refills, or loose e-liquid. With 45 flavours across fruit, ice, candy, and menthol profiles, you can settle on a favourite or work through the range without ever needing a second device.

If you do not own the kit yet, pick up the Crystal Pro CP 10K device to get started. Otherwise, browse the full pod range and find your next flavour.

FAQs

Can I fill these pods with my own e-liquid?

They are sealed units with the coil pre-installed. When the set empties, replace the whole unit with a fresh pod pack.

How long does one pod pack last? 

One to two weeks for most vapers. Heavier users finish closer to a week; lighter vapers stretch further.

Do I need to prime the coil? 

The coil is factory-primed, but Crystal Pro recommends letting the assembled pod sit for 2 to 3 minutes after inserting it into the device before drawing. This ensures the wick is fully saturated.

Can I use the same device battery with different flavour pods? 

The CP 10K device is reusable. Only the pod-and-container unit swaps out. You can load a different flavour every time you replace a pod.

How many flavours are available? 

Twenty, covering fruit, ice, candy, soda, and menthol profiles.