SMOK Morph 80 Replacement LP2 Pods | Pack Of 3

SMOK Morph 80 Replacement LP2 Pods

A 2ml refillable pod that brings your SMOK Morph Pod-80 back to life when the original starts to leak or lose flavour. Sold as a pack of three, the LP2 replacement pod clicks straight onto the Morph 80 and Morph S Pod-80, held firm by strong magnets and filled from the top through a silicone-stoppered port.

It runs the full SMOK LP2 mesh coil range for a warm direct-to-lung draw, so load it with a high-VG juice and you are back in business. Coils are sold separately. Made for the Refillable Pod Kits crowd who refill rather than replace.

Why vapers choose this:

• It is a clean, exact swap for a Morph Pod-80 pod that has cracked, clouded or started weeping around the base, and it seats with the same reassuring magnetic snap as the original.

• Top-fill through a silicone stopper means refills take seconds and stay tidy.

• Runs the whole LP2 mesh range, so you choose the resistance that suits your draw rather than being stuck with one.

• Three per pack. Pods are wear parts, and a spare or two on the shelf saves a dead night.

• Magnetic hold keeps it locked to the device through pocket knocks and daily handling.

SMOK Morph 80 LP2 Pod Features

Two Millilitres, Filled From the Top

The pod holds 2ml in line with UK rules, and the top-fill design is the part you will appreciate daily. A soft silicone stopper lifts to reveal the fill port, so you refill without pulling the pod off the device or fighting a fiddly bung. Quick, clean, no mess down the side.

Why Do the Magnets Matter?

Because a pod that shifts in its housing leaks and loses flavour. SMOK holds the LP2 pod to the Morph Pod-80 with strong magnets rather than a friction fit, so it drops in, clicks, and stays put. No wobble, no gaps for air to sneak past. It just sits where it should.

The LP2 Mesh Platform

This pod is built around SMOK's LP2 mesh coil system, a sub-ohm platform tuned for direct-to-lung clouds. Mesh spreads the heat over a wider surface, which wicks faster and keeps flavour sharper than an old-style wire coil. Stock spares from the wider Replacement Vape Coils range so you are never caught short.

Match It to a High-VG Juice

The LP2 mesh DL coils want a thicker liquid. Aim for 70% VG or higher for the smoothest wicking and the best cloud on the 0.23ohm coil. However, if you opt for the 0.6ohm DC coil, a 50/50 blend or nic salt is the perfect match for its MTL draw. Browse the e-liquid shelves to pair your juice to your chosen coil.

Built as a Wear Part

No pod lasts forever. The plastic clouds, the seals soften, and eventually flavour drops off. That is normal, and it is exactly why these come in a three-pack. Keep one in rotation and the others in the drawer, and a tired pod is a two-minute fix rather than a lost evening.

SMOK Morph 80 LP2 Coil Options

The pod ships empty, so you choose the LP2 coil to match your style. The range is cross-compatible across SMOK's LP2 pods, giving you both DTL and MTL options.

Most popular is the 0.23ohm mesh. It leans into warmer, denser vapour and suits anyone who wants the fuller sub-ohm hit the Morph 80 was built for.

The 0.6ohm DC is the tighter, cooler MTL option. It sips less liquid and less battery, which makes it the sensible pick if you want your juice and charge to stretch further, or prefer a restricted mouth-to-lung pull.

#buttons

• 0.23ohm Mesh
• 0.6ohm DC

How to Fit and Fill the SMOK Morph 80 LP2 Pod

Quick job. A few minutes, most of it just waiting.

1. Press a fresh LP2 coil firmly into the base of the pod until it clicks home.

2. Add three or four drops of e-liquid straight onto the exposed cotton of the new coil.

3. Lift the silicone stopper on the top and fill the pod with a high-VG juice, keeping clear of the central airflow tube.

4. Close the stopper and snap the pod onto the Morph 80, letting the magnets pull it into place.

5. Stand it upright and leave it be for five to seven minutes so the mesh drinks its fill before any power reaches it. Rushing this is how coils get scorched on the first pull.

6. Take two or three gentle draws to settle the wick, then vape as normal.

What's in the SMOK Morph 80 LP2 Pod Box

Three empty LP2 replacement pods, and that is it. No coils, no e-liquid and no device are included, so you supply an LP2 coil and a bottle of juice to get going. Pirate Vapes stocks both alongside the pods, so a full refill kit lands in a single order.

Fits the Morph Pod-80 Family, Nothing Else

These pods are cut specifically for the SMOK Morph Pod-80 and the Morph S Pod-80. If you run either of those, this is your pod.

They will not fit SMOK's other pod systems. Not the RPM series. Not the Nord line. Those use entirely different pod shapes and coil platforms, so a mismatch simply will not seat. When in doubt, check the pod currently in your device says LP2, then browse the wider SMOK Range for anything else you need.

About SMOK

SMOK has spent well over a decade as one of the biggest names in UK sub-ohm vaping, and the LP2 platform is a good example of why. Rather than reinventing the pod with every device, SMOK built the LP2 as a shared standard across several of its kits, so a single coil and pod format carries between them.

The Morph Pod-80 leans on that: a magnetic, top-fill pod with fast-wicking mesh coils, designed to be refilled and replaced cheaply rather than binned in one piece.

Stock Up and Save

Pods wear out on a schedule, so it pays to buy ahead. With three in a pack, most vapers keep one on the device and rotate the spares in every few weeks as flavour fades. Pair a pack with a couple of LP2 coils and a high-VG bottle and you have months of vaping sorted.

Pirate Vapes dispatches every order the same day when it is placed before 4pm, packed to arrive intact. Age-verified checkout, over-18s only, and all hardware is TPD compliant. Free Pirate Post kicks in over £25.

Conclusion

The SMOK Morph 80 LP2 pods are the simple, correct fix for a Morph Pod-80 that has started to tire. A 2ml top-fill pod, magnetic and mess-free, built around SMOK's proven LP2 mesh coils for a warm DTL draw.

Add the coil and juice to suit your taste, keep the spares handy, and your device feels new again. Grab a pack alongside coils and Vape Accessories at Pirate Vapes.

FAQs

Does the Morph 80 pod come with coils?

No. The pack is three empty pods only. You add an LP2 coil and your own e-liquid.

Which coils fit these pods?

The SMOK LP2 range, commonly in 0.23ohm Mesh and 0.6ohm DC. The 0.23ohm gives a warm DTL draw, while the 0.6ohm provides a tighter MTL pull.

What devices do they work with?

Only the SMOK Morph Pod-80 and Morph S Pod-80. They will not fit RPM, Nord or other SMOK pod systems.

How much does the pod hold?

2ml, the UK limit. Fill it from the top by lifting the silicone stopper. No need to remove the pod first.

What e-liquid should I use?

If using the 0.23ohm Mesh coil, a high-VG juice (70% VG or thicker) is best. If you run the 0.6ohm DC coil, a 50/50 e-liquid or nic salt is ideal.

How long does a pod last before it needs replacing?

It varies with use, but a few weeks is typical before the plastic clouds or flavour dulls. That is why they come three to a pack.