SMOK Vape Pen V2 Kit

SMOK Vape Pen V2 Kit

60W of sub-ohm power from a pen that fits in a shirt pocket. The SMOK Vape Pen V2 Kit runs a 1600mAh built-in battery through a 0.15Ω mesh coil and a 2ml top-fill tank, with a single fire button and a dual-slotted airflow ring for the draw.

Built for direct-to-lung vaping and cloud chasers who want simplicity, it detects the coil and sets the power itself, so there is no wattage to dial in. If you want straightforward sub-ohm clouds without a full mod, it is one of the more approachable Vape Kits around.

Why vapers choose this:

• Real sub-ohm clouds from a pen means you get the vapour and flavour of a bigger sub-ohm kit without carrying a mod and separate tank, and the whole thing is one sealed unit.

• Button-fired at up to 60W. Hold, draw, done.

• Dual-slotted airflow ring lets you open it up for loose DTL clouds or close it down for a tighter draw.

• Two 0.15Ω mesh coils in the box. Fast to heat, quick to swap.

• 2ml top-fill tank means fewer refills and no fiddly bottom filling.

SMOK Vape Pen V2 Kit Features

Zinc-Alloy Pen You Can Actually Throw in a Bag

The zinc-alloy chassis gives the Vape Pen V2 a solid, weighty feel at 117.7 x 22mm. It is pen-shaped and pocketable but built to take knocks, which is more than you can say for most plastic starter kits. A sensible pick if you want one durable device rather than a fragile one.

One Button, Three Lights

Operation could not be simpler. A single fire button runs the whole device, and three LED indicators show your battery level at a glance. The device reads the coil and sets its own power, so there is nothing to configure. Good news if menus and screens put you off other sub-ohm kits.

The 0.15Ω Mesh Coil

The included Vape Pen V2 mesh coils heat evenly across a wide surface, which ramps up fast and pushes plenty of vapour. Mesh tends to hold flavour better than round wire as it wears. Pair the coil with a High-VG E-Liquid for the cleanest clouds, since thin, high-PG juice can flood a coil this low.

Dial in Your Draw

The dual-slotted airflow control ring at the base rotates between open and restricted. Open it fully for big, airy DTL clouds, or close it partway if you want a warmer, more contained draw. It has end stops so you cannot spin it off by accident.

Top-Fill, No Mess

Unscrew the top cap, pour your e-liquid in around the central tube, and screw it back on. The threaded top-fill system keeps refills clean and quick, and the 2ml capacity means you are not topping up every hour.

SMOK Vape Pen V2 Kit Colours

The Vape Pen V2 comes in a range of zinc-alloy finishes, from plain blacks through to brighter patterned shells.

#buttons

• Black
• Blue
• Gold
• Raindow
• Red
• Silver

The stocked range shifts by batch, so check the store picker for the finishes currently available before you order.

How to Set Up the SMOK Vape Pen V2 Kit

A little more assembly than a pod kit, but still quick.

1. Unscrew the top cap: Twist off the top cap. Because this is an all-in-one pen, the tank base is permanently fixed to the battery. Do not try to unscrew the base.

2. Install the coil: Screw a 0.15Ω mesh coil clockwise directly into the battery base until snug. Ensure the glass tube is seated properly on the bottom O-ring.

3. Prime the coil: Drip 4 to 5 drops of e-liquid straight onto the exposed cotton ports of the coil to wet it before first use.

4. Fill and seal: Fill the glass reservoir with a 70/30 shortfill or similar high-VG liquid, then screw the top cap back onto the coil to seal the tank.

5. Let it soak: Stand it upright and leave it a full 10 minutes so the coil saturates completely. New sub-ohm coils burn out fast if you fire them dry.

6. Vape: Hold the fire button as you draw. There is no wattage to set, so just inhale and adjust the airflow to taste.

What's in the SMOK Vape Pen V2 Kit Box

Each kit includes:

• The Vape Pen V2 device with its 2ml tank,

• two 0.15Ω Vape Pen V2 mesh coils,

• a USB charging cable,

• and a user manual.

No e-liquid is supplied, so grab a shortfill to get started, and there is no mains plug in the box.

Runs the SMOK Vape Pen V2 Mesh Coil Range

The Vape Pen V2 uses the SMOK Vape Pen V2 Mesh Coil Series, so once your included coils wear out you simply screw in a fresh one rather than replacing the kit. The tank is fixed to the device with no 510 thread, so you cannot fit a different tank on top. Keep to Vape Pen V2 coils, and you are covered.

About SMOK

SMOK has spent over a decade at the front of vaping hardware, and the Vape Pen line is its long-running all-in-one sub-ohm range. The V2 reworked the original Vape Pen 22 with a bigger battery, mesh coils and adjustable airflow, keeping the one-button simplicity that made the range popular with cloud chasers.

It suits DTL vapers who want performance without complexity, and it pairs naturally with a 50ml Shortfill and a nic shot.

Stock Up and Save

Pirate Vapes dispatches orders placed before 4 pm the same day, so a new Vape Pen V2 can be posted the day you order. Everything we stock is TPD compliant and sold age-verified to over-18s only.

Add a couple of spare mesh coils and a shortfill at checkout, and you have a full sub-ohm setup ready to run, with no extra trip needed later.

Conclusion

The SMOK Vape Pen V2 is a durable, no-nonsense sub-ohm pen for DTL vapers, cloud chasers and anyone who wants big vapour without a full mod. Button-fired, top-filled and self-adjusting on power, it keeps things simple while still delivering.

When your coils wear out, stock up from the Replacement Coils range or browse other Reusable Vapes, and head back to Pirate Vapes to build your order.

FAQs

Is the Vape Pen V2 refillable?

Yes. It has a 2ml top-fill tank and replaceable 0.15Ω mesh coils, so you refill with your own e-liquid and swap coils when flavour drops.

Do I set the wattage in the Vape Pen V2?

No. It fires up to 60W and sets power from the coil's resistance automatically.

What e-liquid should I use in the Vape Pen V2?

A high-VG shortfill, ideally 70/30, at a low nicotine strength. Thin high-PG salts can flood a sub-ohm coil like the 0.15Ω mesh.

Which coils fit the Vape Pen V2?

The SMOK Vape Pen V2 mesh coil series. The tank is fixed, so other tanks will not fit.

How long does the Vape Pen V2 coil last?

Usually one to two weeks with a high-VG liquid, though sweet flavours gunk a coil faster.

Can I do mouth-to-lung on the Vape Pen V2?

It is built for DTL. Closing the airflow tightens the draw, but the 0.15Ω coil is a sub-ohm setup at heart.