Vaporesso XROS 4 Mini Replacement Pods

Vaporesso XROS 4 Mini Replacement Pods

When the flavour starts to fade, it is the pod that is worn, not the device. The Vaporesso XROS 4 Mini pods are the genuine refills that bring your kit back to full taste, sold four to a pack. Each 2ml pod carries a COREX 2.0 mesh coil and fills from the top, and the range covers five resistances from a tight MTL draw to a looser RDL one.

They are made for the XROS 4 Mini and slot straight into the wider XROS pod family too. A fresh set of Replacement Pods is the cheapest way to keep a pod kit tasting its best. Pirate Vapes stocks all five resistances.

Why vapers choose these pods:

• Genuine XROS Corex pods. These are the real Vaporesso article, so they seat properly, wick cleanly, and taste as they should from the first fill.

• Five resistances cover everything from a cigarette-tight MTL pull to an airier RDL draw, all in one pod format.

• COREX 2.0 mesh heats evenly for cleaner flavour and a longer coil life than older XROS pods.

• Top-fill and magnetic, so refilling and swapping pods takes seconds.

• A pack of four keeps a daily vaper stocked for weeks before you need to reorder.

Vaporesso XROS 4 Mini Pods Features

Real COREX 2.0 Flavour

Every pod uses Vaporesso's COREX 2.0 mesh coil, which spreads the heat across a wider surface than an old wire coil. In practice, that means the flavour comes through more clearly and the pod holds its taste for longer before it fades. It is a noticeable step up over the pods that shipped with earlier XROS kits.

One Pod Range, Two Draws

Because the same pod comes in five resistances, you can set the XROS 4 Mini to how you like to vape. Fit a higher-resistance pod and close the airflow for a tight mouth-to-lung draw that feels close to a cigarette. Drop to a lower resistance and open it up for a warmer, airier restricted direct lung hit with more vapour.

Built for the Mini, Ready for the Rest

These are the XROS 4 Mini's genuine refills, but they are not locked to it. The COREX pods are cross-compatible across the XROS platform, so if you own more than one XROS device, you can share pods between them. Keep a set of XROS refill pods on hand, and you are covered across the range.

Top-Fill in Seconds

Refilling is about as simple as it gets. Lift the top cap, fill through the port, and drop it back down. The magnetic pod then clicks straight into the device. Vaporesso's SSS leak-resistant design keeps the e-liquid where it belongs while you carry it around.

Match the Liquid to the Pod

Because the resistance range is so wide, coil choice dictates your e-liquid. The 0.6ohm to 1.2ohm pods are built around thinner 50/50 or nic salt e-liquids, wicking cleanly without chasing dry hits. The 0.4ohm pod, however, is a higher-power RDL coil that is built to handle thicker, high-VG shortfills for bigger clouds.

Vaporesso XROS 4 Mini Pods Resistance Options

Five resistances, all COREX 2.0 mesh, all top-fill. The choice sets your draw and the e-liquid that suits best. On the XROS 4 Mini, the device automatically sets the wattage to match whichever pod you fit.

#buttons

• 0.4 Ohm
• 0.6 Ohm
• 0.8 Ohm
• 1.0 Ohm
• 1.2 Ohm

Vaporesso XROS 4 Mini Pods E-Liquid Pairing

For the MTL pods, the 0.8ohm, 1.0ohm, and 1.2ohm, a 10mg or 20mg salt gives the smoothest throat hit and the most disposable-like feel. A pairing of these pods and a bottle of Nic Salts is the classic switcher setup.

The 0.6ohm handles salts too if you prefer a looser draw, but it also works brilliantly with 50/50 freebase. The 0.4ohm RDL pod is the exception: it runs at a much higher wattage and features larger wicking ports, so it requires thicker high-VG (70/30) shortfills. Putting thin 50/50 liquid in the 0.4ohm pod will cause it to leak or spit.

How to Refill the Vaporesso XROS 4 Mini Pods

Quick and clean once you have done it once.

1. Snap the mouthpiece off. You do not need to pull or lift it straight up. Simply push the flat side of the black plastic mouthpiece to snap it off and expose the fill port.

2. Fill through the port with your e-liquid (using the red silicone valve), keeping the tip clear of the central airflow tube.

3. Press the cap back down until it seats firmly.

4. Let it soak. Stand the filled pod upright for four or five minutes so the mesh coil saturates fully.

5. Seat the pod in the XROS 4 Mini until the magnets hold it in place.

6. Take a couple of gentle draws to pull liquid through the coil before you settle into normal vaping.

What's in the Vaporesso XROS 4 Mini Pods Box

Four Vaporesso XROS 4 Mini replacement pods in the resistance you choose. That is the lot. No device and no e-liquid are included, so you will need an XROS 4 Mini already to hand and a bottle of your usual flavour.

Works Across the XROS Pod Family

These pods are made for the XROS 4 Mini, but they share the XROS Corex pod format, so they cross over the wider range. The 0.6ohm, 0.8ohm, 1.0ohm, and 1.2ohm pods fit every current XROS device. The 0.4ohm is the exception: it is a higher-power pod and works with the more powerful models like the XROS 4, XROS 4 Mini, XROS Pro, XROS 5, and XROS 6, rather than the smaller older kits. If you run more than one XROS, the wider Vaporesso Collection has matching kits and parts.

One thing worth knowing: these are the COREX 2.0 pods. The newer XROS 6 ships with COREX 3.0, but both share the same XROS pod connector, so they are interchangeable on the platform. The difference is the coil generation inside.

About Vaporesso

Vaporesso has built the XROS into one of the most recognisable refillable pod systems in the UK, and a big reason is how well the parts hold together across generations. The same pod platform has carried through the whole XROS line, so a pod you buy for a XROS 4 Mini will very likely fit the next XROS you own too.

That kind of consistency is exactly what switchers want: a proven device, a huge shared pod library, and refills you can count on being in stock.

Stock Up and Save

Pods are the one running cost of a refillable kit, so it pays to keep ahead of them. A pack of four covers weeks of daily vaping, and keeping a spare set in the drawer means you are never caught out when a coil finally fades. If you vape the same setup every day, the Crow's Nest subscription takes the reordering off your hands entirely.

Restock your Vaporesso Pods before the last one runs dry, and you will never miss a beat. Every order from Pirate Vapes is dispatched the same day when placed before 4 pm, with Free Pirate Post over £40. With disposable vapes banned since June 2025, refillable pods like these are the sensible way forward. All stock is TPD compliant, checkout is age-verified, and sales are strictly over-18s only.

Conclusion

The Vaporesso XROS 4 Mini pods are a straightforward way to keep a popular pod kit tasting its best. Genuine COREX 2.0 mesh, five resistances to tune your draw, a quick top-fill, and cross-compatibility across the XROS range.

If you run an XROS 4 Mini, these are the refills to keep stocked. Browse more Vape Accessories and grab your resistance at Pirate Vapes.

FAQs

Which devices do XROS 4 Mini pods fit?

They are made for the XROS 4 Mini and share the XROS Corex pod format. The 0.6ohm, 0.8ohm, 1.0ohm, and 1.2ohm fit every current XROS device. The 0.4ohm fits only the higher-power models such as the XROS 4, XROS 4 Mini, XROS Pro, XROS 5, and XROS 6.

Which XROS 4 Mini pod resistance is best for nic salts?

The 0.8ohm for a smooth everyday MTL draw, or the 1.0ohm and 1.2ohm for a tighter, more cigarette-like pull with a stronger salt.

What e-liquid should I use with XROS 4 Mini pods?

Use a 50/50 blend or nic salts in the 0.6ohm, 0.8ohm, 1.0ohm, and 1.2ohm pods. The 0.4ohm pod runs at a much higher power and requires thicker high-VG e-liquids to prevent leaking.

How long does an XROS 4 Mini pod last?

Usually one to two weeks of daily use before the flavour drops off, depending on your e-liquid. Sweeter, darker liquids will shorten that.

Are XROS 4 Mini pods the same as the XROS 6 pods?

They use the same XROS connector, so they are interchangeable on the platform. These are the COREX 2.0 pods, while the XROS 6 ships with the newer COREX 3.0 generation.

Why is my new XROS 4 Mini pod tasting burnt?

Fill it, let it stand a few minutes, and take a couple of gentle draws before vaping properly. Firing a dry or half-primed coil will scorch it.