Aspire Minican Replacement Pods - Pack Of 2

Aspire Minican Replacement Pods

Two 2ml refillable pods per pack, each with an integrated MTL mesh coil, built to keep an Aspire Minican or Minican Plus running long after the first pod tires out. You get a choice of two resistances, a bottom silicone fill port, and a magnetic connection that drops the pod into place with a click.

No coils to fiddle with separately. No mess. Just refill, seat, and go. These are the Replacement Pods the Minican was designed around, and they suit 50/50 nic salt e-liquid best.

Why vapers choose this:

• Two 2ml pods in every pack, which covers most daily MTL vapers for a few weeks before you need another set, and keeps a spare in the drawer for the day one finally gives out.

• Integrated mesh heats a wider surface than old wire coils, so flavour comes through cleaner.

• Magnetic seating means no threading, no alignment, no guesswork. It clicks and it holds.

• Fill from the bottom through a sealed silicone plug.

• Choice of 0.8ohm or 1.2ohm, so you can tune warmth and throat feel without changing devices.

Aspire Minican Replacement Pods Features

Mesh Is Why the Flavour Holds

The integrated mesh coil is the real story here. A mesh strip spreads heat evenly across the wicking cotton instead of concentrating it in a single wire, which means fewer hot spots, less of that scorched edge as the pod ages, and flavour that stays honest right down to the last few fills. For a small MTL pod, that consistency matters more than raw power.

That Magnetic Click, Though

Seating a pod should not be a task, and it is not. The pod holds to the Minican with magnets, so you press it in, and it sits. No screw threads to cross, no rubber gaskets to pinch. When a pod is spent, it lifts straight out, and a fresh one drops in. Honestly, it is the kind of small thing you stop noticing until you use a fiddlier device.

Built Around 50/50 Nic Salts

These pods are tuned for 50/50 nic salt e-liquid, and that pairing is the sweet spot. The balanced ratio wicks properly through the mesh at low power, gives a smooth throat hit, and satisfies fast, which is exactly what most ex-smokers want from a pocket device. Browse the Nic Salts Range and stay at or below 20mg for the tidiest results.

Two Resistances, Two Moods

Pick your draw. The 1.2ohm runs cooler and tighter, closest to a cigarette pull and kind to coil life. The 0.8ohm warms things up and pushes a touch more vapour. Same device, same pods, different feel depending on which one you seat.

Fill It From Underneath

The bottom fill port uses a silicone plug that seals back down flat, keeping liquid where it belongs. Lift the pod, open the plug, top up, close it. The seal is what stops the pocket leaks that plague cheaper pods.

Aspire Minican Replacement Pods Resistance Options

Two resistances are stocked, both integrated mesh, both MTL. The choice comes down to how warm you like the draw and how you want to balance flavour against coil longevity.

Start here if unsure: the 1.2ohm. It is the tighter, cooler option and the one most Minican owners reach for, especially paired with 20mg nic salt. Cigarette-style draw, sensible battery use, and the longest-lasting of the two.

Want a bit more from it: the 0.8ohm. Warmer, slightly more vapour, and a touch more open on the inhale. It pairs nicely with 10mg salts if you find higher strengths too sharp at the extra heat.

#buttons

• 0.8ohm
• 1.2ohm

How to Set Up the Aspire Minican Replacement Pods

Quick swap. Under two minutes start to finish.

1. Lift the old pod away from the Minican. The magnets release with a gentle pull.

2. Open the silicone plug on the base of your fresh pod and add a couple of drops of e-liquid directly onto the exposed cotton to wet the wick first.

3. Fill through the port with your 50/50 nic salt, stopping just below the max line, then press the plug firmly back down until it sits flush.

4. Seat the pod onto the device. The magnets pull it into position and hold.

5. Stand it upright and leave it a full six minutes so the mesh saturates completely before your first pull. Rushing this is what burns a new pod.

6. Start with light, gentle draws. The Minican is draw-activated with fixed output, so there is nothing to dial in. Just inhale, and it fires.

What's in the Aspire Minican Replacement Pods Box

Two Aspire Minican pods in your chosen resistance, sealed and ready to fill. That is the lot. No e-liquid, no device, and no separate coils, since the coil is already built into each pod. You will need your own Minican or Minican Plus and a bottle of compatible salt to get going.

Made for the Aspire Minican Series

These pods fit two devices and only two: the Aspire Minican and the Aspire Minican Plus. Both share the same magnetic pod slot and the same fixed-output setup, so a pod bought for one works in the other.

If your device says Minican on it and the pod drops in magnetically from the top, you are in the right place. Anything from Aspire's MTL Vape Kits that uses a different pod format will not accept these, so match the pod to the Minican specifically before buying.

About Aspire

Aspire built its name on MTL hardware that just works, and the Minican line is that philosophy shrunk to pocket size. The pods lean on Aspire's mesh coil experience, the same engineering focus that runs through the rest of the Aspire Range, applied to a device aimed at simplicity over spec-sheet bragging.

No screens, no menus, no wattage curves. A small draw-activated pod kit and a refillable pod with a decent coil in it. For a lot of vapers stepping down from disposables, that restraint is the whole appeal.

Stock Up and Save

A pack of two covers a few weeks, but the smart move is keeping a set in reserve so you are never caught with a dead pod and nothing to swap in.

Every order from Pirate Vapes ships same day when placed before 4 pm, packed to arrive in one piece. All stock is TPD compliant with an age-verified checkout, over-18s only. Spend over £40 and delivery is on us with Free Pirate Post.

Conclusion

The Aspire Minican pods do one job and do it cleanly: keep a Minican or Minican Plus filled, flavourful, and leak-free. Two 2ml pods per pack, integrated mesh in a choice of 0.8ohm or 1.2ohm, and a magnetic fit that makes swapping effortless.

If you own the device, these are the pods it was built for. Pick up a pack, browse more refills and pods or the wider Vape Accessories selection, and see the full range at Pirate Vapes.

FAQs

Which devices do Aspire Minican pods fit?

The Aspire Minican and the Minican Plus. Both use the same magnetic pod, so one pack works across either device.

What resistances can I get with Aspire Minican pods?

Two. A 1.2ohm for a cooler, tighter draw and a 0.8ohm for a warmer one with a little more vapour.

How much e-liquid do Aspire Minican pods hold?

2ml each, in line with UK rules. Two pods per pack.

What e-liquid should I use with Aspire Minican pods?

50/50 nic salts, ideally 10mg or 20mg. Thicker high-VG liquid will not wick properly through the mesh at this power.

Do I need to buy coils for the Aspire Minican pods separately?

No. The coil is built into each pod. When flavour drops off, you replace the whole pod rather than a separate coil head.

How long does an Aspire Minican pod last?

Most vapers get one to two weeks per pod depending on how much they vape and how sweet the liquid is. Darker, sugary flavours gunk the mesh faster.