Aspire TG Replacement Pods - Pack Of 2

Aspire TG Replacement Pods

Two pods to a pack, both carrying an integrated mesh coil, offered in 0.8ohm or 1.0ohm. The Aspire TG pods are the refill cartridges for the Cyber G family, each holding 2ml of e-liquid and filling through a silicone-plugged port on the side.

The coil sits inside the pod, so there are no separate coil changes: when the flavour dulls, you fit a fresh one and keep going. Pair them with 50/50 or a higher-PG liquid for a clean mouth-to-lung draw. These sit on the wider Replacement Pods shelf at Pirate Vapes.

Why vapers choose this:

• Two resistances in one range means you can run a tighter, cigarette-style pull on the 1.0ohm or open things up for a warmer, airier draw on the 0.8ohm, without owning a second device.

• Mesh coils heat the wick evenly, so flavour stays sharp for longer and the burnt-taste warning arrives later than it would on an old wire coil.

• The whole coil is sealed inside the pod. No coil-fitting, no cotton to prime by hand.

• Magnetic seating. Fast, clean, hard to get wrong.

• Cross-compatible across the Cyber G line, so one pack of pods covers every device in the series you might own.

Aspire TG Replacement Pods Features

Mesh Does the Heavy Lifting

The heating element in every TG pod is Aspire's shaped mesh, not a coil of round wire. Mesh spreads heat across a wider surface, which pulls more flavour from the liquid and wicks more consistently. In practice that means a cleaner taste from the first fill and a pod that keeps performing further into its life. Works well with sweeter Nic Salts too.

Why Two Resistances?

Because draw style is personal. The 1.0ohm runs tighter and cooler, closer to the pull of a cigarette, which suits higher-strength nic salts. The 0.8ohm opens the draw and warms it up, leaning towards restricted direct-to-lung with a touch more vapour. Same pod body, same fill, different feel. Pick by preference.

Filling Through the Side Port

Refills are done from the side, under a small silicone plug near the base. Lift the plug, tuck your bottle nozzle into the port, and fill to just under 2ml. The plug seats back down to keep things sealed in your pocket. It suits 50/50 E-Liquid and higher-PG blends best, since thick high-VG juice struggles to wick through an MTL pod.

Fit It and Forget the Coil

Here is the practical bit. The coil is bonded into the pod, so there is nothing to unscrew, no cotton to hand-prime, no leftover threads gunking up. When a pod tires, you take it out and drop a fresh one in. For anyone who never got on with fiddly coil changes, that is the whole appeal.

One Pod, the Whole Cyber G Family

The same TG pod feeds the Cyber GT, the standard Cyber G and the compact Cyber G Slim. If you started on the Slim and later moved up to the GT, your pods carry over. Handy if you keep more than one Cyber G on the go, or share a range across the house.

Aspire TG Replacement Pods Resistance Options

Two options in the store picker, both mesh, both refillable. The choice is about how tight and how warm you want the draw.

Start with the 1.0ohm if you want the tighter, cooler, cigarette-style pull. It is the closer match for stronger 20mg nic salts and a restrictive mouth-to-lung inhale, so it tends to be the default pick for anyone after a discreet vape.

Step up to the 0.8ohm when you want a little more air and a warmer hit. The draw loosens towards restricted direct-to-lung and vapour picks up, which pairs nicely with slightly lower strengths. Grab a couple of packs through the Plunder Packs if you want to keep both on hand.

#buttons

• 0.8ohm
• 1.0ohm

How to Set Up the Aspire TG Replacement Pods

Quick job. Under two minutes.

1. Pull the empty pod out of your Cyber G device.

2. Lift the silicone plug on the side to expose the fill port. If the pod is bone dry, drip two or three drops of liquid straight onto the visible wick first.

3. Angle your bottle into the port and fill to just below the top, roughly 2ml. Press the plug firmly back into place.

4. Wipe away any stray liquid, then push the pod back until the magnets click home.

5. Leave it standing upright and let the wick drink for a solid five minutes before the first pull. Skip this, and you scorch the coil on day one.

6. Take a few gentle draws to start. On a Cyber GT, begin in the lower power mode and build up from there.

What's in the Aspire TG Replacement Pods Box

Two Aspire TG pods in the resistance you select, and that is the lot. No e-liquid, no device, no charging cable. These are refill cartridges for a Cyber G you already own, so if you are starting fresh, you will need the kit as well.

Made for the Aspire Cyber G Series

The TG pod was built for one range and does its job there properly. It fits the Aspire Cyber GT, the standard Cyber G and the Cyber G Slim, and the cartridges move freely between all three. That cross-compatibility is a real convenience if you upgrade within the line, which is why these belong alongside the Refillable Pod Kits they were designed for.

What they will not fit is the rest of Aspire's pod hardware. Not the Gotek. Not the Flexus. Not the Vilter. Each of those runs on its own separate pod platform, so a TG cartridge simply will not seat. If the pod currently in your device says TG or came out of a Cyber G, you are in the right place.

About Aspire

Aspire's move to fixed-coil pods was a deliberate answer to the biggest complaint about older pod kits: coil changes. By sealing a mesh coil inside a refillable cartridge, the TG platform lets you keep choosing your own liquid and strength while removing the messy part of maintenance.

The Cyber G range is where that idea landed, pairing compact inhale-activated bodies with a pod that fills from the side and clicks in on magnets. It is a sensible, low-fuss system, and it earns its spot on the Aspire Collection at Pirate Vapes.

Stock Up and Save

A two-pack keeps most mouth-to-lung vapers going for a fortnight or more, longer if you are light on it. Refilling from a bottle rather than replacing a device every few days is where the real saving sits, and it stacks up fast.

Order from Pirate Vapes before 4 pm and it ships the same day. All stock is TPD compliant, checkout is age-verified, and it is strictly over-18s only. Spend over £40 and delivery is free with Free Pirate Post.

Conclusion

The TG pods are the simple, refillable way to keep a Cyber G running: two resistances, integrated mesh, and a side port that fills in seconds. Pick the 1.0ohm for a tight, cigarette-style draw or the 0.8ohm for something warmer and airier, then fill with whatever liquid and strength you like so you stay in charge of both flavour and cost.

Browse more options across the refills and pods shelf, keep spares in Vape Accessories, or head back to Pirate Vapes for the full Cyber G lineup.

FAQs

Which devices do the TG pods fit?

The Aspire Cyber GT, the Cyber G and the Cyber G Slim. The pods are cross-compatible across all three, so they carry over if you upgrade within the range. They will not fit Aspire's Gotek, Flexus or Vilter pods.

Can I change the TG pods coil?

No. The coil is sealed into the pod. When it starts to taste burnt or vapour drops off, you fit a fresh pod rather than rebuilding anything.

What e-liquid works best with the TG pods?

50/50 or higher-PG liquid, including nic salts. Thick high-VG juice does not wick well through an MTL pod, so stick to 50/50 or thinner and you will avoid dry hits.

How long does one TG pod last?

Roughly a week to two per pod with daily use. Sweeter, darker liquids cut that shorter as residue builds on the coil faster.

0.8ohm or 1.0ohm, which should I pick for the TG pods?

Go 1.0ohm for a tighter, cooler cigarette-style pull and stronger nic salts. Go 0.8ohm for a warmer, airier draw with a bit more vapour. Many people keep both.

Do the TG pods hold 2ml or 3ml?

In the UK these are the 2ml TPD version. Some overseas listings show a 3ml pod, but the pods sold here follow the UK 2ml limit.