Freemax Fireluke 3 Sub-Ohm Tank

Freemax Fireluke 3 Sub-Ohm Tank

A 0.2ohm 904L X2 mesh coil fitted, a spare 0.15ohm 904L X1 mesh coil in the box, and a 2ml TPD glass ready to fill. That is the short version of the Fireluke 3, Freemax's follow-up to the Fireluke M and Fireluke 2. Both coils are built on FM CoilTech 4.0 and rated for 40 to 80W, so this is a sub-ohm tank aimed at cloud and flavour, not tight MTL puffs.

You get a sliding top-fill, a 510 connection that sits on most box mods, an 810 widebore tip, and six colours to match your setup. Anyone browsing Vape Tanks knows the Fireluke name.

Why vapers choose this:

• Two coils in the box, nothing extra to buy before you start. The 0.2ohm arrives fitted and the 0.15ohm sits ready as a spare, both on FM CoilTech 4.0 mesh, so you can run the tank the day it lands and swap when the first one fades.

• Tea fibre cotton wicking holds flavour cleaner for longer than plain cotton, especially on sweeter shortfills.

• The sliding top cap uses a three-steel-ball catch, so single-handed refills happen without the lid creeping loose in your pocket.

• Dual bottom airflow runs from restricted to wide open.

• A 510 thread means it drops onto nearly any box mod you already own rather than locking you into one device.

Freemax Fireluke 3 Features

CoilTech 4.0 Does the Heavy Lifting

Freemax has iterated its mesh through four generations, and CoilTech 4.0 is where it landed. The mesh is SS904L, a grade that heats fast and copes with sweet High VG E-Liquid without gunking as quickly. Paired with the tea fibre wicking, flavour stays sharp deeper into each coil's life.

Why the Tea Fibre Cotton Matters

Most tanks wick with plain organic cotton. Freemax blends tea fibre into the mix, roughly 95% tea fibre to 5% organic cotton, and the point is heat tolerance. It handles the higher wattages these coils run at, which means fewer early dry hits and a longer stretch before the flavour drops off. Worth it, honestly.

That No-Leak Top Cap

Slide the lid open from the marked point, tip your liquid into the single port, slide it shut. The three steel balls add friction so the cap stays put when the tank is idle in a bag or pocket. Older Fireluke lids could work loose. This one holds.

Dial the Airflow to Taste

The dual slotted airflow ring at the base swings from a tight, flavour-focused draw to a wide, cloud-heavy one. Wind it shut and the vapour concentrates. Open it right up and the Fireluke 3 breathes. Restricted direct-to-lung or full DTL, the tank covers both without swapping any parts.

Built to Take a Knock

Stainless steel body, reinforced glass, and an 810 widebore tip that pulls plenty of vapour to the mouth. When the glass eventually cracks, and sub-ohm glass does, you replace it rather than the whole tank. Keep spare Replacement Tank Glass in the drawer.

Freemax Fireluke 3 Colours

Six colours, all carrying the same tank underneath. Pick on looks alone.

#buttons

• Black
• Blue
• Green
• Orange
• Red
• Yellow

How to Set Up the Freemax Fireluke 3

First fill takes a few minutes. Rushing it kills the coil.

1. Unscrew the tank from your mod and take off the base to reach the coil housing.

2. Thread the 0.2ohm coil into the base until finger-tight, then drip three to four drops of e-liquid straight onto the exposed mesh and cotton.

3. Reassemble the tank and slide the top cap open from the marked point.

4. Fill with a high VG shortfill through the single port, keeping the liquid below the max line, then slide the cap shut.

5. Stand the filled tank upright for a full ten minutes so the tea fibre cotton saturates completely before you fire it.

6. Start low, around 40W, and step up in small increments until the draw feels right.

What's in the Freemax Fireluke 3 Box

One Fireluke 3 tank with the 0.2ohm 904L X2 mesh coil already fitted, plus a spare 0.15ohm 904L X1 mesh coil. You also get a replacement glass, a spare O-ring, and the user guide. No e-liquid, no mod, and no batteries. You supply the liquid and a 510 device to sit it on, both easy to sort at Pirate Vapes.

The Sub-Ohm Tank for Any 510 Box Mod

The Fireluke 3 uses a standard 510 thread, so it fits nearly any regulated box mod with the power to reach 40 to 80W. Browse compatible Vape Mods if you need a device to pair it with. The 904L X mesh coils it runs are shared with the Fireluke M and Fireluke 2, so any existing Freemax coil stock carries straight over.

What it will not do is fit a pod system or a low-powered pen. This is a sub-ohm DTL tank, and it needs a proper mod behind it. It also will not take non-Freemax coils, so stick to the 904L X range.

About Freemax

Freemax made its name on mesh. While other brands were still running round wire, Freemax pushed mesh coils into the mainstream and kept refining them across the Fireluke series. The Fireluke M set the template, the Fireluke 2 tightened it, and the Fireluke 3 brings the SS904L mesh and tea fibre wicking together under CoilTech 4.0.

The brand's focus has always been flavour and cloud from a sub-ohm tank, and the Fireluke line is where that reputation was built. It is a hardware specialist, not a liquid house.

Stock Up and Save

A refillable sub-ohm tank changes the maths. Instead of buying a new disposable every couple of days, you fill this one from a shortfill bottle and only replace the coil when it fades. Over a month, the saving is real.

Pirate Vapes dispatches every order same day before 4pm, and all hardware sold is TPD compliant with an age-verified checkout for over-18s only. Keep a couple of spare coils on hand and you are set.

Conclusion

The Fireluke 3 is a straightforward pick if you want dense clouds and clean flavour from a refillable sub-ohm tank. Two coils in the box, a top-fill that stays shut, airflow that swings from restricted to wide open, and a 510 fitting that suits most mods.

When the coils wear, fresh Freemax Coils and the odd bit of Vape Accessories keep it running for the long haul. Grab yours from Pirate Vapes and pair it with a mod that hits 40 to 80W.

FAQs

What wattage should I run the Fireluke 3 at?

Both coils are rated 40 to 80W. Start at 40W and climb until the flavour peaks for you. Push past 80W and you will burn through cotton fast.

Does it fit my mod?

If your mod has a 510 thread and reaches 40W, yes. Most regulated box mods do.

What e-liquid works best in the Fireluke 3?

High VG shortfills. A 70/30 or higher VG ratio wicks well through the mesh and produces the clouds this tank is built for. Thin 50/50 nic salt is the wrong match here.

How much liquid does it hold?

2ml in the UK TPD glass. Enough for a solid session before a top-up.

Can I use my old Fireluke coils?

The 904L X mesh coils are shared across the Fireluke M, Fireluke 2, and Fireluke 3, so existing stock fits. Older non-X Fireluke coils do not.

How often will I replace the coil?

Depends on your liquid and wattage. Sweet shortfills at higher power might see a week or two. Lighter use stretches it longer.