SMOK RPM 85 and RPM 100 Replacement Pods

SMOK RPM 85 and RPM 100 Replacement Pods

Two pod versions, one job: keeping your SMOK RPM 85 or SMOK RPM 100 running without buying a whole new kit. These are the 2ml TPD refillable pods for both devices, sold in a pack of 3, and you choose the fitment that matches your coils. The RPM 3 pod takes SMOK's RPM 3 mesh coils for airier sub-ohm draws.

The RPM 2 pod runs the wider RPM 2 range for a tighter pull. Top-fill, magnetic seating, clear body so you can watch your level drop. Coils are sold separately, so keep a couple of spare Replacement Pods in the drawer.

Why vapers choose this:

• Two fitments, one device. Whether you run the punchy RPM 3 mesh for clouds or the more flexible RPM 2 range for a tighter draw, there is a pod here that fits the RPM 85 and the RPM 100 without any adapters or workarounds.

• 2ml top-fill means you slide, drip, and go. No pulling the pod off the mod every refill.

• Magnetic seating drops the pod in and holds it firm, so it does not creep loose in a pocket.

• A locking coil base keeps the coil seated and the liquid where it belongs.

• Sold in threes. One in use, two in reserve.

SMOK RPM 85 and RPM 100 Replacement Pods Features

Pick the Pod That Matches Your Coils

This is the only choice that matters. The RPM 3 pod accepts SMOK's RPM 3 mesh coils for warm, open sub-ohm vaping around 40 to 80W. The RPM 2 pod takes the broader RPM 2 range, from low-ohm mesh up to a 0.6 DC head for a tighter pull. Fit the pod to your coils, and you cover everything from airy clouds to a snugger draw, which is why they suit vapers stepping across Refillable Pod Kits.

Why Bother With Top-Fill?

Because it is faster and cleaner. Slide the cap across, drip your liquid into the port, close it. The pod stays on the device the whole time. No unscrewing, no juice on your fingers, no fishing around under a tank base. Honestly, once you have used a sliding top cap, going back feels like a chore.

The Locking Base That Stops the Wobble

Push-to-fit coils are quick, but a loose coil leaks and tastes flat. SMOK's locking base clamps the coil in place so it stays put and seals the join at the same time. It also means the coil cannot be tugged out by accident, which is a bit of quiet reassurance if there are curious hands about the house.

Snap It On and Go

The pod holds to the mod with magnets rather than a clip, so seating it is a one-handed job. Pull it off to refill or swap versions, drop it back, and the contacts line up on their own. Small thing, but it is the sort of detail you notice every single day.

Airflow You Can Actually Dial In

These pods work seamlessly with the adjustable airflow ring built into the top of your RPM 85 or RPM 100 device. Simply twist the dial on the mod to tune your draw from restricted to fully open without changing coils. Pair that with the clear pod body, and you always know two things at a glance: how tight your airflow is set and how much liquid you have left.

SMOK RPM 85 and RPM 100 Replacement Pods Options

There are two versions in the range, and they are not interchangeable once a coil is in. The right pick is decided by the coils you own, not by looks, since both share the same shell and the same 2ml well.

Most vapers land on the RPM 3 pod first, because both kits ship with RPM 3 coils in the box. It is built for airier direct-to-lung vaping and drinks thick juice, so pair it with 70VG sub-ohm liquid from the 70-30 Shortfills range at around 3 to 6mg.

The RPM 2 pod is the one to grab if you prefer a firmer draw or already have RPM 2 coils. Fit a higher-resistance head like the 0.6 DC, and it leans towards a restricted, cooler pull that works nicely with Nic Salts or a balanced 50/50.

#buttons

• RPM 3 pod
• RPM 2 pod

How to Set Up the SMOK RPM 85 and RPM 100 Pods

Under two minutes, coil included.

1. Push your chosen coil up into the base of the pod until it clicks, and the lock engages.

2. Slide the top cap open and put 2 to 3 drops of e-liquid straight onto the exposed cotton first.

3. Fill with e-liquid to just below the max line, then slide the cap shut.

4. Seat the pod on the mod. The magnets pull it square on their own.

5. Stand the device upright and leave it a full seven minutes so the wick draws liquid all the way through before you fire it.

6. Start low and build up. Take a few gentle pulls, then climb to your coil's wattage.

What's in the SMOK RPM 85 and RPM 100 Pods Box

Three empty pods in your chosen fitment, either the RPM 2 or the RPM 3 version. That is the lot. No coils, no e-liquid, and no device. These are spares for a kit you already own, so anything you need to actually vape gets added separately.

Built for the RPM 85 and RPM 100, and Nothing Else

These pods seat in two devices only: the SMOK RPM 85 and the SMOK RPM 100. They will not fit the older RPM or RPM 2 kits. They are not Nord pods either. The part people trip on is the coil match.

An RPM 3 pod takes RPM 3 coils. An RPM 2 pod takes the RPM 2 range. Cross the two and the coil simply will not lock in. Grab your Vape Coils to suit, and Pirate Vapes keeps the SMOK line grouped so you are not hunting across the site.

About SMOK

SMOK, run by Shenzhen IVPS, has been one of the loudest names in sub-ohm hardware for well over a decade. The RPM family is where the brand folded pod convenience and mod-level power into a single shell. The RPM 85 and RPM 100 are the current standard-bearers of that idea: real wattage, a colour screen, swappable coils behind a refillable pod.

These pods are the part that wears with use, so keeping genuine SMOK spares to hand is the cheapest way to keep either kit tasting the way it should.

Stock Up and Save

Pods outlast coils, but they do not last forever. Seals soften, the plastic clouds up, and flavour dulls off the back of it. A pack of 3 lets you rotate a fresh one in before that point and hold a spare for the version you are not currently running.

Pirate Vapes dispatches every order the same day before 4 pm in padded packaging. All stock is TPD compliant, checkout is age-verified, and sales are over-18s only.

Conclusion

If you own an RPM 85 or RPM 100, a spare three-pack is one of those quiet buys you will be glad of the next time a pod gives out mid-week. Choose the fitment that matches your coils, keep the box topped up, and the kit carries on earning its place.

Pair them with fresh Vape Accessories and browse the full hardware range at Pirate Vapes.

FAQs

Which pod do I need for my kit?

Go by your coils. RPM 3 coils need the RPM 3 pod. RPM 2 coils need the RPM 2 pod. Both versions fit the RPM 85 and the RPM 100 without any bother.

Do RPM 85 and RPM 100 pods come with coils?

No. Coils are sold separately, so add the RPM 2 or RPM 3 heads to match your chosen pod.

How much do the RPM 85 and RPM 100 pods hold?

2ml, in line with UK TPD rules. A larger 6ml version exists in some overseas markets, but the pods sold here are the 2ml UK spec.

What e-liquid works best with the RPM 85 and RPM 100 pods?

For the RPM 3 pod, reach for 70VG shortfills at 3 to 6mg. If you fit a higher-ohm coil in the RPM 2 pod for a tighter draw, switch to a 50/50 or a nic salt instead.

Why is my RPM 85 and RPM 100 pod leaking?

Usually the coil is not fully locked in, or the pod was overfilled. Push the coil up until it clicks and fill to just below the max line, not over it.

How long does a RPM 85 and RPM 100 pod last?

Weeks, not days. Most vapers swap the pod itself every one to three weeks, while the coil inside gets changed more often.