Vaporesso Gen Air 40 Replacement Pods - Pack Of 2

Vaporesso Gen Air 40 Replacement Pods

Two empty 2ml refillable pods, built for one device and nothing else: the Vaporesso Gen Air 40. Each cartridge fills through a silicone-stoppered port on the side, takes the full GTX mesh coils through a press-fit fitting, and clicks onto the battery magnetically.

The AOP airflow switch sits on the pod itself, so you tighten or loosen the draw without touching the device. SSS leak-resistance keeps the liquid where it should be. No coils in the pack, so pair them with your chosen GTX Mesh Coils. Refillable, rechargeable, over 18s only.

Why vapers choose this:

• A spare on the device and one in the drawer. Two pods per pack means you are never stuck when a cartridge finally gives up, and the flavour turns muddy.

• The airflow control lives on the pod, so your draw stays exactly how you set it.

• Press-fit GTX coils drop straight in. Swap the coil, keep the pod.

• SSS leak-resistance keeps liquid off your pocket and away from the battery contacts.

• Genuine 2ml TPD cartridges made to hold consistent flavour and vapour across a full tank.

Vaporesso Gen Air 40 Replacement Pods Features

One Pod, the Whole GTX Coil Family

The Gen Air 40 pod is not fussy about coils. It runs the GTX mesh range, which spans tight MTL resistances around 1.2ohm through to lower-ohm restricted DTL heads. Pick a warmer, cloudier draw or a cigarette-style pull, then change your mind next week. Same pod, different coil.

Why Put the Airflow on the Pod?

Because it stays put. The AOP switch is built into the cartridge, so once you dial in the draw, moving the device around in a bag does not knock your setting loose. Tighten it right down for a snug MTL pull, or open it for a looser, airier hit. Small detail, genuinely useful.

Fill It From the Side

Lift the silicone stopper, tip the nozzle in, top up to just under the max line, press the stopper back down. No dismantling, no removing the coil. Best paired with Nic Salt E-Liquids or a 50/50 freebase for the higher-ohm coils. Two minutes, done.

Magnetic Click, Nothing to Line Up

The pod holds to the device with magnets. Drop it in, feel it seat, vape. When a coil eventually wears out, you pull the pod, press in a new head, and carry on. No screw threads to cross, no O-rings to fight.

Leaks Handled Before They Start

Vaporesso's SSS system seals the pod at the points that usually weep: the fill port, the coil housing, the airflow path. It is the difference between a pod that lives happily in your pocket and one that leaves a sticky mess. This one behaves.

Which Coil to Run in the Gen Air 40 Pods

No coils ship in the box, so the resistance is your call. The store carries the GTX mesh heads that fit this pod, and the right one depends on how you like to vape.

Most vapers start with the 0.8ohm. It sits in that comfortable middle: a warm mouth-to-lung draw at roughly 12 to 16W, good with 50/50 juice or nic salts, and it lasts. If you want more warmth and a touch more vapour, the 0.6ohm at around 20 to 26W steps things up. Chasing a fuller, restricted-DTL draw? The 0.4ohm at 26 to 32W is the one. Prefer a tight, high-resistance MTL closer to a cigarette pull? The 1.2ohm runs low and slow and outlasts the rest.

#buttons

• 0.4ohm
• 0.6ohm
• 0.8ohm
• 1.2ohm

Run 50/50 E-Liquids or nic salts through the higher-ohm heads, and save thinner high-PG blends for the low-resistance mesh.

How to Set Up the Vaporesso Gen Air 40 Replacement Pods

Quick job. Under two minutes once you have done it once.

1. Take a fresh pod and press a GTX coil into the base until it clicks home.

2. Add three to four drops of e-liquid straight onto the cotton showing through the coil.

3. Open the silicone stopper on the side and fill to just below the max line, keeping clear of the central airflow tube.

4. Press the stopper shut and click the pod onto the device. The magnets do the aligning.

5. Let it stand upright for a full six minutes before the first pull, so the wick soaks right through. Fire it dry, and you cook the coil.

6. Start at the low end of the coil's wattage and build up gradually.

What's in the Vaporesso Gen Air 40 Pods Box

Two empty 2ml refillable pods and nothing else. No coils, no e-liquid, no device. These are pure replacement cartridges for people who already run the Gen Air 40 and need a fresh pod, so keep a set of GTX coils and a bottle of juice to hand.

Made Only for the Vaporesso Gen Air 40 Kit

These pods fit the Vaporesso Gen Air 40 and only that kit. They are the correct cartridge for that specific device in the wider family of Vaporesso Refillable Pod Kits, and every order from Pirate Vapes is the genuine part.

What they will not fit: the XROS series, the Luxe range, or any other Vaporesso pod that looks close but runs a different pod platform. If your current cartridge came out of a Gen Air 40, these are the ones. If it came from anything else, they are not.

About Vaporesso

Vaporesso built the GTX coil platform to do one clever thing: let a single pod cover everything from a tight MTL puff to a restricted-DTL cloud, just by changing the coil inside. The Gen Air 40 leans on exactly that.

Rather than lock you into one draw style, the pod accepts the whole mesh range, so the device grows with your taste instead of aging out. That cross-coil flexibility is a large part of why Vaporesso pods stay popular long after the kit first lands.

Stock Up and Save

Pods are a consumable. The coil inside wears, the flavour dulls, and eventually the cartridge itself needs retiring. Keeping a two-pack in reserve means a five-minute swap instead of a dead device and a wait. Grab a spare set now, and you are covered for weeks.

Every order from Pirate Vapes ships same day before 4 pm in padded packaging. TPD compliant, age-verified checkout, over 18s only. Free Pirate Post on orders over £40.

Conclusion

The Gen Air 40 pods are a simple, honest replacement part: two genuine 2ml cartridges, side filling, magnetic seating, and full GTX coil compatibility that lets one pod cover MTL through restricted DTL.

If you own the kit and the flavour has gone flat, this is the fix. Browse the full Vaporesso Range, stock up on Vape Accessories, and grab your pods from Pirate Vapes.

FAQs

Which device do the Gen Air 40 pods fit?

Only the Vaporesso Gen Air 40. They are the exact cartridge for that kit and will not seat in other Vaporesso pods.

Do the Gen Air 40 pods come with coils?

No. Empty pods, two per pack. You add your own GTX coils.

What is the Gen Air 40 pods capacity?

2ml, in line with UK TPD rules. The same pod is sold as a larger 4.5ml version in some overseas markets, but UK stock is the 2ml cartridge.

Can I run nic salts in the Gen Air 40 pods?

Yes, and they suit it well. Pair salts with a higher-ohm MTL coil like the 0.8ohm or 1.2ohm for a smooth, tight draw at low wattage.

How often should I replace the Gen Air 40 pods?

The coil goes first, usually one to two weeks with daily use. The pod shell lasts longer, but once flavour dulls even with a fresh coil, or the plastic clouds and stains, swap the whole cartridge.

Are the Gen Air 40 pods MTL or DTL?

Both, depending on the coil. High-ohm heads give a tight mouth-to-lung pull. The 0.4ohm opens it up into restricted direct-to-lung.