Innokin Go-S Disposable Tank

A 1.6ohm Kanthal coil sealed inside a 2ml tank that you never open, never maintain, and never rewick. That is the entire pitch. The Innokin Go-S is a disposable MTL Tank with a slide-open top fill, adjustable bottom airflow, and a 510 thread that screws onto pen batteries and box mods alike.

Fill it with 50/50 or higher-PG e-liquid, vape it until the flavour goes flat, bin it, screw on a fresh one. Coil changes? Gone. Priming anxiety? Gone. The whole thing runs at 10 to 14W and sits at just 20mm across. Food-grade PCTG plastic, organic cotton wicking blended with wood-pulp, and three colours in the store picker. Over 18s only.

Why vapers choose the Go-S Tank:

• No coil swaps. Period. The coil lives inside the tank permanently. Flavour drops off after a couple of weeks, you toss the tank and click a new one on. Costs about the same as a standalone replacement coil from most brands, so the maths works out.

• Adjustable airflow at this price is unusual, and it genuinely matters. The bottom ring takes the draw from cigarette-tight all the way to a slightly open MTL pull. Most disposable tanks give you one fixed draw, and that is that.

• Slide-fill keeps things clean. Push the top cap across, tilt your bottle in, slide it shut. No removing the tank from the battery, no dripping into awkward ports.

• Wood-pulp in the wicking is an Innokin touch. It pulls liquid faster than pure cotton, which means fewer dry hits when the tank runs low. You notice it.

• 510 thread screws onto basically anything. Your old box mod collecting dust? This fits it.

Innokin Go-S Disposable Tank Features

Coil Changes Are the Worst Part of Vaping. So Skip Them.

Think about it. Replacement coils for most MTL tanks run somewhere between £2 and £5 each. The Go-S tank costs about the same, coil included. So you are paying roughly equivalent money, except you also get a fresh tank body, fresh wicking, a fresh silicone seal, and zero chance of a botched prime ruining the coil before you have even taken a draw. Nobody misses the ritual of unscrewing a gunked-up coil with sticky fingers. This just removes it.

Honestly, the Airflow Ring Is What Sells It

Fixed-draw disposable tanks are everywhere. They all feel the same: tight, slightly scratchy, take it or leave it. The Go-S has a multi-hole airflow ring on the base, and rotating it makes an actual difference. Closed down, you get that really restricted cigarette-pull that heavy MTL vapers want. Crack it open one or two notches, and the draw softens up, lets a bit more vapour through. Obviously it is not going to compete with a full sub-ohm adjustable setup, but for something you bin after a fortnight? Impressive.

What Does Wood-Pulp Wicking Actually Do?

Innokin mixes wood-pulp into the organic cotton inside the Go-S coil. Sounds odd. Works well. Wood-pulp fibres absorb liquid faster than cotton alone, so when you chain vape through a stressful afternoon, and the tank level drops below a quarter, the wick keeps up. Pure cotton struggles in that situation. You get a papery dry hit and wonder if the coil has died. The wood-pulp blend buys you more time before that happens. Not infinite time. But enough.

510 Means It Fits More Than Just the Go-S Pen

Innokin designed this tank for their own Go-S Pen Kit. Makes sense. But the 510 threaded connection underneath is the same universal fitting that most regulated mods, pen batteries, and tube devices have used for years. So if you already own a 510 mod and just want a cheap, maintenance-free MTL tank to throw on top, the Go-S does the job. Keep it under 14W though. Push it higher, and you will taste burnt cotton within minutes, and the tank is done.

The Fill System That Actually Prevents Mess

Slide the top cap in the direction of the arrow. That is it. Port opens, you angle your bottle nozzle in, fill to just below the line, push the cap back. Silicone seal clicks into place. No unscrewing the tank from the battery. No inverting the device. Thin-nozzle bottles work best because the fill port is not massive, but most 10ml and 30ml bottles fit without any trouble.

Innokin Go-S Disposable Tank Colours

Three options. All the same food-grade PCTG plastic body with a slight translucency, so you can eyeball your liquid level without pulling anything apart.

#buttons

• Black
• Blue
• Pink

How to Set Up the Innokin Go-S Disposable Tank

Quick job. A minute or two at most.

1. Got an old tank on the battery? Unscrew it anticlockwise and set it aside.

2. Unbox the new Go-S. Slide the top cap open by pushing the mouthpiece in the direction of the printed arrow. Do not fire the device yet.

3. Fill with your chosen 50/50 E-Liquid or nic salt. Thin-nozzle bottle, angled in gently, stop just below the max line.

4. Push the top cap back until the silicone seal snaps shut.

5. Stand the tank upright and wait a solid seven minutes. Seriously, set a timer. The wood-pulp and cotton blend inside the coil needs to soak through properly from the tank walls inward. Fire it dry and the cotton chars. Once that happens, every draw tastes burnt for the rest of the tank's life. No fixing it.

6. Screw the tank onto your battery. First few draws, go gentle. Flavour starts slightly muted and sharpens up within five or six puffs once the wick is fully saturated.

What's in the Innokin Go-S Disposable Tank Box

One tank. Your colour. Coil pre-installed and sealed inside.

No e-liquid. No battery. No spare anything. If you need a compatible device, the Innokin Go-S Pen Kit is the natural pairing. Any 510-threaded battery or mod at 10 to 14W works too.

The Go-S Fits Anything With a 510 Thread

Standard 510 connection. That covers most regulated box mods, pen batteries, tube mods, and plenty of older devices sitting in drawers across the country. It threads directly into Vape Tanks slots on any of those without adaptors, spacers, or workarounds.

Does not fit pod kits. Not the magnetic ones, not the snap-in ones, not the press-fit ones. If your device uses proprietary pods, the Go-S is the wrong product.

Wattage matters too. The 1.6ohm coil was built for 13W. Some devices let you run it between 10 and 14W safely. Higher than that and the organic cotton burns out fast. You will know immediately because the flavour goes acrid.

About Innokin

Innokin has been around since the early days of UK vaping. Longer than most brands people actually recognise. The Go-S line is their answer to a specific problem: vapers who like the form factor of a tank but cannot be bothered with coil maintenance. Practically speaking, the Go-S sits halfway between a classic tank and a modern pod.

You get the 510 threading and the adjustable airflow of a proper tank, but when the coil degrades, you replace the whole unit like you would a pod. Their Go-Z and Go-Z+ models use swappable Replacement Coils if you prefer keeping the same tank body and just changing the coil head, but the Go-S strips even that step away.

Stock Up and Save

Here is the maths on these. One Go-S tank lasts somewhere between ten days and three weeks depending on how heavily you vape and how much sweetener is in your liquid. Sucralose kills coils faster than anything else, honestly. Grab two or three tanks at once, and you have got a month or more covered without thinking about it.

Pirate Vapes dispatches same day before 4 pm, everything padded. TPD compliant stock, age-verified checkout, over-18s only. Spend over £25 and delivery is free with Free Pirate Post.

Conclusion

The Go-S is not trying to be clever. A 1.6ohm Kanthal coil inside a 2ml PCTG tank with adjustable airflow and a slide-fill top cap. When the coil is finished, you replace the tank. No maintenance, no spare parts, no fuss. The 510 thread fits nearly everything, and the price per tank is roughly what you would spend on a replacement coil anyway.

If you want simple MTL vaping without any of the upkeep, this is it. Browse the full Innokin collection and Vape Accessories at Pirate Vapes.

FAQs

What devices does the Go-S fit?

Anything with a 510 thread running between 10 and 14W. Built for the Innokin Go-S Pen, but it screws onto most box mods and pen batteries from other brands too. Not for pod systems.

How long does a Go-S tank last?

Depends on use. Ten days to three weeks is typical. Sweeter liquids wear the coil faster because sugar residue cakes onto the cotton.

Can I use nic salts?

Absolutely. The 1.6ohm coil and tight MTL draw were basically made for nic salts. Go with 50/50 VG/PG at 10mg or 20mg.

What is the difference between Go-S and Go-Z?

Big one. The Go-S coil is permanent. Coil dies, whole tank gets replaced. The Go-Z uses swappable Z coils, so you keep the tank and only change the coil inside. Go-S is simpler. Go-Z saves money long-term if you vape heavily.

Does adjusting the airflow actually do anything?

Yes, and it is not even close to a gimmick. Fully closed is a very tight cigarette-style draw. Open it up, and the pull gets noticeably looser. Real difference between the two extremes.

Will thick e-liquid work in this?

No. High-VG juice will not wick properly through the cotton and wood-pulp blend at 1.6ohm. The ports are too narrow. Stick with 50/50 or higher-PG blends or you will get dry hits within a few draws.