Innokin Go-Z Vape Pen Kit

One button. Press it, vapour comes out. Release it, vapour stops. That is genuinely the entire user experience with the Innokin Go-Z. 13W fixed output, no screen, no menus, no wattage adjustment. A Pen-Style MTL Kit that runs on Innokin's Z coil system at a price lower than most pod kits.

The tank is food-grade PCTG plastic instead of glass, so it survives being dropped, sat on, and rattled around in a bag. 1500mAh built-in battery. 2ml slide-to-open top-fill tank. Stainless steel body. Six colours. 510 thread. The Go-Z is aimed at people who do not want to learn about vaping. They just want to vape. Over 18s only.

Why vapers choose this:

• One button. 13W. Fixed. Nothing to configure, nothing to get wrong.

• 1500mAh battery at 13W output means a full day of use. Possibly two for light vapers.

• Z coil system from Innokin. Same coils used in the Zenith and Zlide tanks. Proven, widely stocked, excellent MTL flavour.

• PCTG plastic tank instead of glass. Does not crack. Slide-to-open fill with silicone seal.

• Stainless steel body, 510 thread, six colours. Costs less than most pod kits.

Innokin Go-Z Vape Pen Kit Features

Press the Button. That Is the Manual.

No wattage dial. No temperature control. No OLED screen. No five-click menu system. The Go-Z fires at 13W when you hold the button down. Let go, and it stops. Five rapid clicks turns it on, five turns it off. A green LED means the battery is fine. Amber means it is getting low. Red means plug it in. That is everything. The entire interface. And honestly, for a huge number of vapers, especially people switching from smoking who do not want a tech project, this is exactly the right amount of complexity. Which is to say, almost none.

Z Coils in a Kit That Costs Almost Nothing

This is the bit that does not quite make sense until you think about it. The Go-Z uses Innokin's Z Coil Platform. Same coils that go into the Zenith tank. Same coils that go into the Zlide on the Kroma R. The 1.6 ohm Kanthal coil that ships pre-installed is the single most popular MTL coil Innokin has ever made. Tight draw, clean flavour, reliable performance. You are getting that coil quality in a pen that costs less than a lot of people spend on a Friday night takeaway. The maths on that is hard to argue with.

The Tank Will Not Crack Because It Is Not Glass

Food-grade PCTG plastic. Not Pyrex. Not borosilicate. Plastic. And before that sounds like a downgrade, think about where a pen kit actually lives. Pocket with keys. Bottom of a handbag. Work desk where it gets knocked over twice a day. Glass tanks crack. This one does not. The PCTG is food-grade certified, optically clear, and tougher than any glass tube on the market. For a device that is going to get bumped around, it is the better material.

1500mAh at 13W Goes a Very Long Way

Do the maths on battery drain at 13 watts. It is low. Really low. Most MTL vapers pulling on the Go-Z throughout a normal day will get home with battery left over. Lighter users can stretch it into a second day without trying. When you do charge it, the Micro USB port on the back handles it. Micro USB is not the fastest standard, but at this battery capacity and this drain rate, it fills up in a reasonable amount of time.

Stainless Steel, 20mm Diameter, Fits Anywhere

The Go-Z is a tube. 20mm across, 129mm tall with the tank on. Thin enough to slip into a shirt pocket. Light enough that you forget you are carrying it. The stainless steel body gives it a solid feel despite the slim profile, and the brushed or coloured finish holds up well against daily handling. Six colour options. No two-tone gimmicks. Just a clean pen with a clean finish.

Innokin Go-Z Vape Pen Kit Colours

Six options. Same stainless steel and PCTG across the board.

#buttons

• Black
• Silver
• Red
• Blue
• Pink
• Gun Metal

How to Set Up the Innokin Go-Z Vape Pen Kit

1. Charge it fully. Micro USB into the back of the pen. The LED ring glows during charging and turns green when done. Start with a full battery.

2. Slide the tank open and fill. Push the top section of the tank sideways. The fill port opens. Pour in 50/50 E-Liquid or nic salt. The silicone seal stops liquid from escaping during filling. Slide it shut.

3. Wait. The 1.6 ohm Z coil is already in the tank. After you fill, stand the pen upright and leave it alone for six minutes. The cotton inside the coil is wound tight. It takes time to pull liquid through. 

4. Five clicks, then vape. Press the fire button five times quickly. LED flashes. Hold the button, draw. No wattage to set. No modes to select. Done.

What's in the Innokin Go-Z Vape Pen Kit Box

• One Go-Z pen. 

• One GO-Z 2ml PCTG tank. 

• One 1.6 ohm Kanthal Z coil already sitting in the tank. 

• One Micro USB cable. 

• User manual. 

No spare coil. Only one ships in the box. No e-liquid. Buy your own nic salt or 50/50 Liquid before the kit arrives. And honestly, order a pack of replacement Z coils at the same time. One coil gets you started, but it will not last forever.

Runs Z Coils, Fits 510 Tanks, Handles 50/50 Liquids

The Go-Z tank takes the full Z (Zenith) coil range. The 1.6 ohm Kanthal that comes installed is the tightest MTL option. You can also run the 1.2 ohm for slightly more warmth or the 0.8 ohm for a looser, restricted draw. Z Plex3D mesh coils fit too.

The pen has a 510 thread, so technically you can screw on a different tank. Worth knowing, though anything wider than 20mm is going to overhang the pen body and look odd.

E-liquid: 50/50 VG/PG only. Nic salts at 10mg or 20mg. Freebase at 6mg to 12mg if you prefer. Do not put High-VG (70/30) Liquid in the Go-Z. The coil ports are small, and thick liquid will not feed through properly. You will get dry hits and wonder what went wrong.

Browse Innokin coils for replacement Z coils in every resistance.

About Innokin

Innokin has been making beginner-friendly vape hardware for longer than most brands have existed. Endura T18. Jem Pen. EQ FLTR. All devices built on the same idea: strip the complexity out and let someone who has never vaped before pick the thing up and use it. 

The Go-Z follows that exact approach. One button, fixed wattage, Z coils, done. Innokin manufactures in Shenzhen, China, and has built a following among UK vapers who value a kit that works reliably without needing a YouTube tutorial to set up. Browse the full Innokin Collection at Pirate Vapes.

Stock Up and Save

One coil in the box. One. A coil lasts roughly one to two weeks depending on how much you vape and how sweet your liquid is. A five-pack of Replacement Z Coils covers you for over a month. Add a few bottles of nic salt, and you are sorted. Every order ships securely packed with full tracking. Age-verified checkout, same-day dispatch before 4 pm. Over 18s only. Spend over £25 and delivery is free with Free Pirate Post.

Conclusion

The Go-Z does not try to impress you with features. It impresses you by working. One button, 13W, Z coil flavour, a 1500mAh battery that runs all day, and a PCTG tank that will not crack no matter how badly you treat it.

Costs less than most pod kits on the market and uses one of the most reliable coil systems in vaping. If someone asks you what they should buy as their first vape kit, the Go-Z is a genuinely good answer. Pick one up at Pirate Vapes.

FAQs

Does the Innokin Go-Z Vape Pen Kit have adjustable wattage?

No. 13W. Fixed. Constant. Press the button; it fires at 13W. Release, it stops. No settings, no adjustments.

What coils does the Innokin Go-Z Vape Pen Kit use?

Z (Zenith) coils by Innokin. 1.6 ohm Kanthal comes pre-installed. The 1.2 ohm, 0.8 ohm, and Z Plex3D mesh coils also fit the Go-Z tank.

What e-liquid works best in the Innokin Go-Z Vape Pen Kit?

50/50 VG/PG. Nic salts at 10mg or 20mg. That is what the 1.6 ohm coil at 13W is designed for. Keep 70/30 high-VG liquids away from the Go-Z. The coil cannot handle them.

How long does the Innokin Go-Z Vape Pen Kit battery last?

1500mAh at 13W. A full day for regular MTL vapers. Lighter users can push into a second day. The low wattage barely drains the battery.

Is the Innokin Go-Z Vape Pen Kit good for beginners?

It is arguably the best beginner vape pen you can buy. One button, no screen, no settings. Fill the tank, click five times, hold the button, vape. If someone has never touched a vape before, the Go-Z is about as simple as it gets.