Innokin Prism Apex Tank

Innokin Prism Apex Tank

Adjustable airflow is the real upgrade here. The Innokin Prism Apex Tank takes the proven Prism-S coil format and adds a bottom airflow ring, so you can dial the draw from tight MTL to a looser RDTL.

It is a 2ml top-fill tank on a 510 thread, with a 0.9ohm mesh coil fitted and a 0.8ohm spare in the box. Stainless steel, Pyrex glass, 22mm across. If your old Prism tank never let you tune the draw, this MTL Vape Tank fixes exactly that.

Why vapers choose this:

• Airflow you can actually tune. The bottom ring closes right down for a sharp, cigarette-tight MTL and opens up for a looser RDTL, so one tank covers both draw styles rather than locking you into one.

• Mesh coil fitted. The 0.9ohm Prism-S mesh heats more evenly than the older wire coils, which sharpens flavour and helps the coil last.

• Top fill. Unscrew the cap, fill to 2ml, close it. No need to take the tank off the mod.

• 510 thread fits the majority of variable wattage mods, not only the Innokin kit.

• Takes the whole Prism-S range, so existing T20S owners can carry on using the coils they already have.

Prism Apex Features

Adjustable Airflow

The bottom adjustable airflow ring is the headline change. Spin it closed for the tightest, most cigarette-like draw the Prism Apex offers, or open it towards a restricted direct-lung feel. Most MTL vapers settle somewhere in the middle. It is a small control that makes the tank far more flexible than the fixed Prism tanks before it.

0.9Ω Mesh Coil For Better Flavour

Because mesh spreads heat across a wider surface than a standard wire coil. The fitted 0.9ohm Prism-S mesh runs at 14.5-18W and gives a cleaner, more consistent flavour that holds up as the cotton ages. You get more vapour too, without pushing the coil hard. Spare Replacement Coils are worth keeping in a drawer.

Easy Unscrew Top Fill

Refilling is refreshingly simple. The knurled top cap unscrews fully, revealing the fill port set in a deep recess, so liquid goes where it should and not over your fingers. Screw it back down, and it seals tight. You do not even need to remove the tank from your mod to top it up.

Ideal For Nic Salts

This tank is built for nic salts and 50/50 juice. Run a Nic Salt at 20mg with the airflow closed down, and the tight MTL draw feels familiar to anyone coming off cigarettes. Dropped your strength already? A lower-strength 50/50 with the airflow opened out suits the 0.8ohm coil nicely.

Easy Push-Fit Coil Change

Coils drop in from the base with two flats that line up against notches inside the tank, then push into place. No cross-threading or wet connection. Pull the spent coil, align and press the new one in, refill. That is the whole job.

Prism Apex Colours

The Innokin Prism Apex is stocked in six finishes. Pick whatever suits your mod.

#buttons

• Black
• Blue
• Green
• Grey
• Pink
• Purple

How to Set Up the Prism Apex

1. Unscrew the base and push-fit your Prism-S coil, lining up the two flats with the notches inside.

2. Drip a few drops of e-liquid onto the exposed cotton so it is not bone dry.

3. Screw the tank onto your 510 mod.

4. Unscrew the top cap, fill to the 2ml line, then close it.

5. Let the wick soak through for a few minutes, five or so, before your first pull.

6. Set the airflow; start at 14.5W and step up towards 18W across the first tank.

What Is in the Box

You get:

• The Prism Apex tank with the 0.9ohm mesh coil pre-installed,

• a spare 0.8ohm Prism-S coil,

• a set of spare O-rings

• and a user manual.

There is no e-liquid and no mod supplied, so you will need your own 50/50 or high-PG juice and a compatible device to run it.

Fits Any 510 Mod, and the Whole Prism-S Range

The Prism Apex uses a 510 threaded connection, so it screws onto most variable wattage Box Mods that cover roughly 14-18W, not only Innokin hardware. It takes the full Prism-S T20S coil range: the fitted 0.9ohm mesh (14.5-18W), the 0.8ohm (16-18W), and the 1.5ohm (13-14W) for the tightest draw.

Existing Endura T20-S and EZ.WATT users can reuse their coils here. If you would rather buy the whole setup, take a look at our MTL Vape Kits. Note that this is an MTL tank, so it is not built for high-wattage sub-ohm vaping.

About Innokin

Innokin has spent years refining the Endura and Prism lines into a byword for reliable, low-fuss MTL vaping. The Prism Apex is the current step in that story, bringing adjustable airflow and the newer mesh coil to a coil system that ex-smokers already trust.

It keeps everything people liked about the T20S, then adds the draw control that the tank lacked. For anyone who wants dependable mouth-to-lung hardware without a learning curve, Innokin remains one of the easier names to recommend.

Stock Up and Save

Coils are consumables, so keeping spares to hand is the sensible move, and Pirate Vapes stocks the Prism-S range alongside the tank so you are never stuck on a tired coil. Order before 4 pm on a weekday for same-day dispatch.

Checkout is age-verified and strictly over 18s only, and everything we list is TPD compliant, so you always know exactly what you are buying.

Conclusion

The Prism Apex is a dependable MTL tank that finally gives the Prism line adjustable airflow, a fitted mesh coil, and clean top filling. Two coils in the box, six colours and a 510 fit make it an easy upgrade or replacement.

Grab spares from the Innokin Collection, round out your setup with Vape Accessories, and shop the full range at Pirate Vapes.

FAQs

What coils does the Apex use?

The full Prism-S T20S range: a 0.9ohm mesh comes fitted, a 0.8ohm is the spare, and a 1.5ohm is sold separately for the tightest draw.

Will the Apex fit my mod?

If your mod has a 510 connection and covers roughly 14-18W, yes. It suits most variable wattage mods, not just Innokin ones.

How is the Apex different from the T20S?

Adjustable airflow and a fitted mesh coil. The T20S had a fixed draw. The Apex lets you tune it from tight MTL to a looser RDTL.

What e-liquid should I use with the Apex?

A 50/50 or high-PG blend, and nic salts work well. High-VG liquids above 70% will not wick fast enough at this wattage and can cause dry hits.

Why does the Apex coil taste burnt quickly?

Usually a priming issue or too much power. Fill, wait five minutes before firing, and keep to the coil's wattage range.

How many colours are there in the Apex?

Six: Black, Blue, Green, Grey, Pink and Purple, all the same price.