Uwell Crown V Vape Tank

Uwell Crown V Vape Tank

Two mesh coils in the box, both sub-ohm, both built for direct-to-lung clouds. The Uwell Crown V is a 2ml refillable sub-ohm tank on a threaded 510 connection, shipping with a 0.23ohm UN2 single mesh coil fitted and a spare 0.3ohm UN2-2 dual mesh coil alongside it.

Liquid goes in through a quarter-turn top cap, and the draw is set with a dual-slotted airflow ring at the base. It suits vapers who already run a mod and want warm, flavour-forward vapour. One of the more sensible DTL Tanks Uwell has made, and the glass, O-rings, and drip tip cover are all included.

Why vapers choose this:

• Two coils, two moods, zero extra spend. The single mesh 0.23ohm throws bigger clouds and a cooler draw, while the dual mesh 0.3ohm runs a touch warmer and, in most people's testing, pulls slightly richer flavour. You get both in the box to work out which one you prefer.

• Press-fit coils mean you pull the old one out and push the new one in. No threading, no cross-threading, no fuss.

• Self-cleaning tech draws residual condensation back through the structure, which cuts down on the pooling and gurgling that plagues a lot of sub-ohm tanks.

• Quarter-turn top fill. Press, twist, fill.

• Stainless steel through and through, hand-polished at the edges, so it takes the knocks a daily-carry tank picks up without looking battered a fortnight in.

Uwell Crown V Features

Pro-FOCS For Consistent Flavour

Uwell's Pro-FOCS system manages the heating temperature across the mesh so the e-liquid vaporises more evenly. In plain terms, you get a cleaner, more consistent flavour from the first fill to the last, rather than that flat, muted taste a coil drifts into. Pair it with a decent High VG E-Liquid, and the difference is obvious.

Self-Cleaning Design For Less Mess

Condensation is the enemy of any sub-ohm tank. It pools, it leaks, it gurgles. The Crown V pulls that residual liquid back through its own structure during normal use, so you spend less time wiping down the base and airflow. Not magic, just clever engineering, and it genuinely reduces the mess.

Mesh Coils For Warm, Dense Clouds

Both supplied coils are mesh, and mesh heats faster and across a wider surface than old wire builds. The result is quicker ramp-up and denser vapour. Run the 0.23ohm wide open for airy DTL clouds, or restrict the airflow a little on the 0.3ohm to concentrate the flavour. When they wear out, fresh Uwell Coils slot straight back in.

Adjustable Dual-Slotted Airflow

The dual-slotted airflow ring sits at the base and turns smoothly, with two large opposing air holes feeding the coil. Open it right up for the loosest, coolest draw. Close it down a fraction, and the flavour tightens and the vapour warms. It holds its position on the mod too, so it does not drift while it is in your pocket.

Replacement Glass And O-Rings Included

Most tanks these days ship bare. This one gives you a replacement glass, a pack of O-rings, and a drip tip cover from the off. Small thing, but it means your first crack or lost seal is not an instant reorder. Worth its weight, honestly.

Uwell Crown V Colours

Six finishes in the store picker, all on the same hand-polished stainless steel body. The mirror finishes catch the light more; the darker tones hide fingerprints better. Choose whichever sits best against your mod, and grab a spare Drip Tips And Mouthpieces cover if you tend to misplace them.

#buttons

• Black
• Blue
• Gunmetal
• Red
• Silver
• Yellow

How to Set Up the Uwell Crown V

Quick job. Five minutes with the soak.

1. Twist the base off the tank and lift out the pre-installed coil if you are fitting the spare.

2. Push the fresh coil firmly into the base until it seats. It is press-fit, so no screwing.

3. Wet the exposed mesh through the side ports with three or four drops of e-liquid, then add one drop down the centre so the cotton is not dry anywhere.

4. Reassemble, then press and quarter-turn the top cap and fill the glass with high-VG liquid.

5. Close it up and stand the filled tank upright for a solid ten minutes so the mesh saturates fully before you fire it.

6. Start low, around 40W, and climb toward the coil's rated range until the draw feels right.

What's in the Uwell Crown V Box

Each tank arrives with:

• the 0.23ohm UN2 coil pre-installed,

• a spare 0.3ohm UN2-2 coil,

• a full replacement glass,

• a pack of spare o-rings,

• a drip tip cover,

• and the user manual.

That covers your first coil swap and your first breakage without a second order. It does not include any e-liquid, and it does not include a mod or battery, so you will need a 510 device to run it. A spare Replacement Tank Glass is worth keeping in the drawer for later.

Fits Any 510 Mod You Already Own

The Crown V uses a standard threaded 510 connection, so it drops onto essentially any regulated box mod with the wattage to match. Uwell's own mods are an obvious pairing, but this tank is happy on most Vape Mods that reach 55 to 70W. What it will not do is fit pod systems or MTL pen kits.

It is a sub-ohm DTL tank that needs real power behind it, so a small pod device simply cannot drive these coils properly. Match it to a mod that can, and it performs. If you are unsure whether your setup fits, the team at Pirate Vapes can point you to the right pairing.

About Uwell

The Crown line is one of the longest-running sub-ohm tank series in vaping, and it is largely how Uwell built its UK reputation. Each generation has pushed the coil tech forward, and the fifth iteration leans on the UN2 mesh family and Pro-FOCS flavour tuning to get more out of the same 2ml.

Uwell hardware has a name for solid stainless builds and coils that last, which is exactly why the Uwell Vapes range stays a staple for daily DTL vapers rather than a passing trend.

Stock Up and Save

Coils are the recurring cost with any sub-ohm tank, so it pays to keep spares of both the 0.23ohm and 0.3ohm on hand rather than waiting for a burnt hit.

Pirate Vapes dispatches every order the same day when it is placed before 4 pm, with Free Pirate Post on orders over £40. All hardware is sold to over-18s only through an age-verified checkout, and every tank ships TPD-compliant at the 2ml UK capacity.

Conclusion

The Uwell Crown V is a straightforward, well-built sub-ohm tank for anyone running a mod who wants warm clouds and clean flavour without babysitting their kit. Two mesh coils in the box let you settle on a draw you like before you spend a penny more, and the included spares soften the running cost.

Keep it fed with fresh Vape Coils and the odd spare part from our Vape Accessories shelf, all from Pirate Vapes.

FAQs

What resistances come with the Crown V?

Two. A 0.23ohm UN2 single mesh coil, pre-installed, best around 65 to 70W, and a spare 0.3ohm UN2-2 dual mesh coil that suits roughly 50 to 55W.

Does the Crown V fit my mod?

If your mod has a 510 connection and reaches around 55 to 70W, yes. It will not fit pod kits or MTL pens.

How much liquid does the Crown V hold?

2ml, in line with UK regulations. Refill through the quarter-turn top cap.

Is the Crown V MTL or DTL?

Direct-to-lung. Both supplied coils are sub-ohm mesh, so this is a warm, airy, cloud-focused vape, not a tight cigarette-style draw.

Can I buy a triple mesh coil for the Crown V?

Yes. The tank takes the wider Crown V coil series, including the 0.2ohm UN2-3 triple mesh coil sold separately.

How long does the Crown V coil last?

It varies with wattage, liquid, and how much you vape, but mesh coils in a tank like this typically give you a week or two of daily use before the flavour drops off.