VooPoo PnP Pod II Replacement Pods

VooPoo PnP Pod II Replacement Pods

One pod, the entire PnP coil library behind it. This is the empty 2ml refillable pod for VooPoo's newer Drag kits, the E60 and H80S, and it accepts any coil from the PnP range VooPoo has built over the years, RBA builds included. Moulded from PCTG, it seats coils on a press-fit, holds on by magnet, and adjusts its airflow when you rotate the pod itself.

Resistance spans a sub-ohm 0.1ohm cloud coil right up to 3.0ohm for a tight pull, so it covers DTL and MTL depending on what you drop in. Coils are sold separately. Browse the full Replacement Pods range.

Why vapers choose this pod:

• It opens the door to VooPoo's entire PnP coil catalogue, which spans low-resistance mesh cloud coils, mid-range restricted-lung options, higher-ohm MTL coils and even a rebuildable RBA deck, all in one pod shell.

• Airflow adjusts on the pod. Twist it, and the draw tightens or opens, no separate ring to fiddle with.

• Two per pack keeps a spare ready.

• Genuine PCTG rather than brittle acrylic, so it takes a knock and stays clear.

• The magnet seats it blind, which sounds minor until you have lined up threads in a dark cinema.

VooPoo PnP Pod II Features

The Whole PnP Coil Library, One Pod

This is the real draw. VooPoo has released dozens of PnP coils across the years, and this pod takes the lot. Sub-ohm mesh for dense clouds, mid-range coils for a restricted lung hit, higher-resistance options for salts, and an RBA deck if you build your own. You are not locked into two resistances. You get the whole ecosystem. Match your coil to the VooPoo Coils that suit your style.

Twist the Pod, Change the Airflow

Neat bit of engineering, this. Rather than a separate airflow ring, the pod uses a gear-coupling base: rotate the pod in the device, and the intake opens or closes. Turn it wide for airy DTL clouds, turn it down for a tighter draw. The adjustment sits under your thumb once the pod is seated, so you dial the draw in without pulling anything apart.

Sub-Ohm Clouds or a Tighter Pull?

Both, and that is the point of the 0.1ohm to 3.0ohm range. Drop in a low-resistance mesh coil and, on a Drag E60 or H80S, you get proper direct-lung vapour. Fit a higher-ohm coil instead, and the same pod pulls tight and cool for salts. One cartridge covers the two ends most vapers bounce between. Pairs naturally with the DTL Tanks crowd if clouds are your thing.

PCTG, Because Cheap Pods Crack

The shell is PCTG, the tougher clear plastic manufacturers use when they want a pod to survive daily life. It resists the cracking and clouding that citrus and menthol liquids inflict on softer materials, and it keeps the e-liquid window see-through so you can watch your level. Not glamorous, but it is why this pod does not haze over after a fortnight.

RBA-Ready for the Tinkerers

Worth flagging for the hands-on crowd: the pod accepts VooPoo's PnP RBA deck, so you can build your own coils and wick them yourself. That is a rare thing in a pod this convenient. Most people will run standard coils and never look back, but the option is there, and it makes the pod a genuinely flexible base.

Pairing the PnP Coils

The pod is only half the setup. The PnP coil you press in decides everything about the draw, so a quick steer helps. Your wattage ceiling depends on the device too: the E60 tops out around 60W, the H80S nearer 80W. Every option lives in the wider Vape Kits ecosystem and coil range.

Best for clouds: the low-resistance mesh coils, the PnP-VM and PnP-TW families around 0.15ohm to 0.3ohm, run roughly 30W to 55W. These are the direct-lung, high-vapour picks, best with high-VG liquid and low nicotine.

Middle ground: coils around 0.45ohm to 0.6ohm for a restricted lung draw. Cooler, less thirsty, a sensible everyday choice if full DTL feels like too much.

Tighter and cooler: higher-resistance options nearer 1.0ohm and up, which suit an MTL pull and 10mg salts. Not the pod's natural home, but it handles them.

How to Set Up the PnP Pod II

Quick job, a minute or two.

1. Lift the old pod clear of the device. The magnet releases with a firm upward pull.

2. Press a PnP coil into the base of a fresh pod until it clicks fully home.

3. Wet the coil first: drip three or four drops of e-liquid into the coil's wicking ports so the cotton is not dry before filling.

4. Open the side-fill stopper, top up with your chosen liquid to just below the max line, and press the stopper firmly back in.

5. Stand the filled pod upright for a full ten minutes. Sub-ohm mesh coils hold a lot of cotton, and they need the time to soak. Fire one dry, and you will taste the burn for the life of the coil.

6. Click the pod into the device, take a few gentle priming pulls without firing, then start low and build the wattage up to the coil's range.

What's in the PnP Pod II Box

Two empty 2ml PnP Pod II cartridges and two replaceable drip tips. No coil, no e-liquid, no device. You add a PnP coil and your liquid separately, and the Drip Tips And Mouthpieces range covers you if you want to change the feel of the draw.

The Cartridge Built for the Drag E60, H80S and H40

This pod is cut for VooPoo's newer Drag generation, chiefly the E60, H80S, and H40. It seats the full PnP coil family, so the coils cross over widely even though the pod shell is specific to these kits. It is not the original PnP pod from the older Drag S, Drag X, or Vinci devices, and it will not fit those.

If your device is a Drag E60, H80S or H40, and the coils you buy say PnP, you are sorted. Fill it with the right liquid from the High VG E-Liquid range for the sub-ohm coils.

About VooPoo

VooPoo's PnP platform is one of the most widely copied coil systems in vaping, and for good reason. A single press-fit coil format that carries across a huge span of devices, from tiny pod kits to full box mods, means you rarely have to hunt for the right coil.

The PnP Pod II is the current expression of that idea: a pod that takes the entire back catalogue of PnP coils plus a rebuildable deck. VooPoo pairs this with its GENE chip on the device side, but the pod's strength is simpler than that. It is the sheer breadth of coil choice.

Stock Up and Save

Here is the ecosystem case for a spare pack. Because this cartridge takes every PnP coil going, one pod outlives dozens of coil swaps, so a two-pack lasts a long while and lets you switch between a cloud coil and an MTL coil without cross-contaminating flavours. Keep one pod on each and swap as the mood takes you.

Every order from Pirate Vapes ships same day before 4 pm, checkout is age-verified, and all stock is TPD compliant and for over-18s only. Free Pirate Post lands on orders over £40.

Conclusion

The PnP Pod II is the most flexible pod VooPoo makes: a 2ml refillable shell that accepts the entire PnP coil range, adjusts airflow by a twist, and swings from sub-ohm clouds to a tight MTL draw on the strength of the coil alone. Built for the Drag E60 and H80S, and RBA-ready for anyone who builds.

If your old pod is leaking or the flavour has gone flat, a fresh two-pack sorts it. Explore the wider VooPoo Range and stock up on Vape Accessories at Pirate Vapes.

FAQs

Do PnP Pod II pods come with a coil?

No. They are empty. You add a PnP coil and your own e-liquid separately.

Which devices do PnP Pod II pods fit?

The Drag E60, Drag H80S and Drag H40. They are not the original PnP pod and will not fit older Drag S, Drag X or Vinci kits.

Can I use PnP Pod II pods for both clouds and MTL?

Yes, that is the appeal. A low-resistance mesh coil gives direct-lung clouds; a higher-ohm coil tightens it up for salts. Same pod, different coil.

How do I adjust the airflow in the PnP Pod II?

Rotate the pod once it is seated in the device. The gear-coupling base opens or closes the intake as you turn it.

What e-liquid should I use in the PnP Pod II?

For sub-ohm cloud coils, a high-VG liquid at low nicotine. For higher-resistance MTL coils, 50/50 or salts at 10mg suit better. Match the liquid to the coil, not the pod.

How long does the PnP Pod II pod last?

The coil wears out first and gets swapped often. The PCTG pod carries on for weeks, until the plastic clouds, cracks, or the seal weakens. That is your signal for a fresh one.