Aspire Cleito Replacement Coils - Pack Of 5

Aspire Cleito Replacement Coils

The coil that ditched the chimney. Aspire's Cleito coils use a full-length coil sleeve in place of the central chimney most tanks rely on, which frees the airflow for big DTL clouds and bold flavour.

Built on claptonised Kanthal wire wrapped in organic cotton, they come as a pack of 5 in sub-ohm resistances from 0.2ohm to 0.4ohm, each suited to warm, airy sub-ohm vaping on high-VG juice. If you run a Cleito tank, these are the Vape Coils it was built around, and they slot into the wider DTL Tanks world too.

Why vapers choose the Cleito coils:

• No chimney, more air. The full coil sleeve replaces the tank's central chimney, so the draw is wide open and the vapour and flavour come through with barely any restriction. This is the whole reason the Cleito vapes the way it does.

• Claptonised Kanthal ramps up fast and holds heat evenly across the wrap.

• Organic cotton wicks cleanly, so flavour stays true from the first pull rather than tasting of cotton.

• A pack of five covers weeks of daily use, and sub-ohm burns through heads faster than MTL.

• Three resistances let you tune warmth and cloud size just by picking the head, no mod settings needed.

Aspire Cleito Coils Features

The Chimney-Free Design That Started It

Most sub-ohm tanks of the era ran a fixed chimney up the centre. The Cleito threw that out and turned the coil sleeve into the airway itself. The result is a famously open draw with a short, direct path from coil to mouthpiece, which is where the big clouds and clean flavour come from.

Why Claptonised Wire?

A Clapton coil wraps a fine wire around a thicker core, a bit like a guitar string. That extra surface area holds more liquid against the heat and warms up quickly, so you get a faster ramp and a richer, fuller flavour than a plain round-wire coil of the same resistance would give you.

Made for High-VG Juice, Not Salts

These are sub-ohm heads, so they drink thick, sweet liquid and turn it into vapour. Feed them 70/30 or higher High VG E-Liquid at low nicotine, around 3mg to 6mg. Thin 50/50 will spit and struggle, and high-strength salts through a sub-ohm coil are genuinely harsh.

Fast Ramp, Even Heat

The wound Kanthal build hits temperature quickly, so there is very little delay between pressing fire and getting vapour. Heat spreads evenly along the wrap rather than pooling in hot spots, which keeps the flavour consistent and stops the cotton scorching prematurely. Small engineering details, but you notice them over a coil's life.

Change It When the Flavour Turns

A coil tells you when it is done. When the flavour dulls, the clouds shrink, or you catch a faint burnt edge on the exhale, that is your cue to fit a fresh head. Pushing a tired coil past that point just ruins the taste and can gunk the tank.

Aspire Cleito Coils Resistance Options

Three wound resistances make up the core range, plus a stainless steel option for temperature control. The right one comes down to how warm and how big you want the vape.

#buttons

• 0.15 ohm
• 0.2 ohm
• 0.27 ohm
• 0.4 ohm

How to Set Up the Aspire Cleito Coils

A quick job once the tank is empty. Do not skip priming.

1. Empty the tank, unscrew the base, and pull the spent coil out of the base section.

2. Take a fresh Cleito head and drip four or five drops of e-liquid into each of the wicking ports around the coil body, then one more drop straight down the centre onto the exposed cotton.

3. Screw the new coil firmly into the tank base until it seats. Do not overtighten it.

4. Reassemble the tank, fill with your high-VG juice, and stand it upright for three to four minutes so the cotton saturates through.

5. With the mod switched off, take two or three dry pulls to draw liquid deeper into the wick.

6. Start low, near the bottom of the coil's range, then step the wattage up until the flavour and vapour feel right.

What's in the Aspire Cleito Coils Box

Each pack holds five genuine Aspire Cleito coils in your chosen resistance. That is all it is: no tank, no e-liquid, no glass, just the coils. Pirate Vapes keeps genuine Aspire heads in stock, so a burnt coil never means a dead tank for long.

Made for the Aspire Cleito Tank Family

These heads are built for Aspire's Cleito line. That covers the original Cleito tank, the Cleito EXO and the Cleito Pro, all of which share the same coil fitment, plus the K4 kit, which runs a Cleito tank. What they will not fit is the Cleito 120, which uses a completely different, larger coil.

They also have nothing to do with Aspire's MTL tanks. Not the Nautilus. Not the Atlantis. Not the Triton. Each of those runs its own coil platform. Check the full Aspire Vapes range if you are unsure which head your tank takes.

About Aspire

Aspire has been making tanks and coils since 2013, and the Cleito was one of its landmark releases. The idea was simple but sharp: drop the central chimney every sub-ohm tank used at the time and turn the coil itself into the airway.

That one change gave the Cleito a famously open draw and set the template for the airflow-first sub-ohm tanks that followed. These coils are the genuine replacement for that platform, and running anything but authentic heads usually costs you flavour and coil life. If you ever crack the glass, Replacement Tank Glass is a cheap fix.

Stock Up and Save

Sub-ohm coils work hard, so they do not last as long as MTL heads. Heavy daily use at 55-70W can see a 0.2ohm head tire inside a week, while a gentler 0.4ohm stretches further. A pack of five keeps you going for a month or so, and picking up two packs means you are never caught with a burnt coil and no spare.

Pirate Vapes ships every order the same day before 4 pm, with Free Pirate Post over £40. All stock is genuine, TPD compliant, and sold to over-18s only through an age-verified checkout.

Conclusion

The Cleito coils are the reason the tank vapes the way it does. The chimney-free design gives an open, cloudy DTL draw, and the claptonised Kanthal keeps the flavour rich as long as you feed it high-VG juice and keep the wattage in range.

If you own a Cleito, EXO, Pro or K4, genuine heads are the only sensible replacement. Stock up alongside your Vape Accessories and grab a pack from Pirate Vapes.

FAQs

Which tanks do the Cleito coils fit?

The Cleito, Cleito EXO and Cleito Pro, plus the K4 kit. Not the Cleito 120, and not any Aspire MTL tank.

What e-liquid should I use with the Cleito coils?

High-VG, 70/30 or higher, at low nicotine of 3mg to 6mg. Nic salts and thin 50/50 are the wrong fit for a sub-ohm coil like this.

How long does a Cleito coil last?

Depends on power and juice. Roughly one to two weeks with daily use. Sweet, dark liquids gunk the cotton faster and cut that shorter.

Can I use the Cleito coils for MTL?

No. These are sub-ohm DTL heads. A tight mouth-to-lung draw needs a different coil and tank entirely.

Which resistance should I start with the Cleito coils?

The 0.4ohm. It runs at sensible wattage, lasts reasonably well and gives a balanced flavour-and-cloud vape. Step down to the 0.2ohm later if you want more.

Do I need a powerful mod for the Cleito coils?

Yes. Sub-ohm coils pull high current, so use a regulated mod with a healthy battery that can safely handle a 0.2ohm to 0.4ohm load.